VLTOR rifle mod stock keeps getting unscrewed

I have Stag lower which came with Stag A2 receiver extension. I removed the A2 stock and installed VLTOR rifle modstock on it. For the second time in a year and a half I noticed wobble in my stock and a 2mm gap between the stock and receiver. It turns out the the stock has gotten slightly loose… I am not sure if it’s my receiver extension or the stock that’s causing the issue.
I hand tighten the extension and grease the extenstion threads lightly and use the VLTOR provided screw with blue lock tite.
What could be causing the issue?

Thanks!

I just want to be sure that I am understanding you. The stock itself is loosing up or the receiver extension? If it’s the receiver extension then it sounds like it is not torqued correctly. If it is the stock itself then I would say that you need to clean the threads of the screw and apply new Loc-Tite.

The receiver extension should be torqued to 35ft lbs

Hand tightening wont do the job. Tourque like Todd said.

I hope not to be splitting hairs, but the extension wouldn’t move after I tightened it, could it be under 35 ft/lb still?
What tool are out there that would allow me to do it?
I have Firearms Acquirizing Torgue wrench from Midway, but couldn’t find an adapter to fit the extension.

Youra asking why it is turning on you and the reason s hand torquing instgoing to do it.

This worls and is cheap

http://www.gearsector.com/browse/category/tools/stock-removal-tools/

Thanks for the link Shihan. Just ordered.