How hard is this to replace? Thanks.
It’s held in with a flared pin. Make a wood block with a escape hole for the pin for it to rest on. Then take a pin punch and 3# hammer and knock the pin out. That spring will then go sideways and grab everything up on you. Just pull the punch back out and finish pulling the pin out from the other side.
Reinstallation is trickier. Tough to hold it all in position with that spring doing it’s thing. I use padded vice grips to help hold it in place and put a punch through to hold it in place. Then tippy tap the pin back in with a small hammer and as you put the pin into place, let it push the punch back out the other side. Once done, set it on a steel anvil with no hole and use a flared 45 degree tip punch and a 3# hammer to re-flare the ends of the pin to retain it in place. Done.
Hope that helps.
Thanks. One of my latches seems to need more ‘metal’ on top.