if you’ve got one, post a pic. I need some ideas.
Certainly!
Specs:
PWA Lower
CMT/Stag LPK
Vltor buttstock with “H” buffer
Magpul trigger guard
TD Battle Grip
CMT/Stag upper receiver
Sabre Defense 1:7 twist mid-length barrel
CMT/Stag MP’d BCG
CMT/Stag CH
Larue 9.0 rail
EoTech 552
Larue EoTech Riser
Larue BUIS
TD Vertical Grip (Carrying a spare bolt and firing pin)
Up next:
Blue Force/Vickers Tactical Sling
Nitrox- is that coyote with OD KG on your rifle?
What’s on the front of your gear, outside of the mag compartments? Shotgun shells?
No, that is the new tactical Ranger Coyodrab. If you were tacticool you would know that.
Yes, shot gun shells. Shot guns suck, they are my arch nemesis.
good reason to have the shells then…
those are some nice guns…my DD rail should come in at the end of the week, along with a few other parts. once i get it all together i will post a pic
Here’s a few. Hope to receive a lower back from Stag today or tomarrow. It’s going on a mid-length as well. I’ll try to have pics of the newest mid-lenght up by the end of the week.
and the uppers new home (until I armbend KAC for a lower 
)
and get one of Magpuls new stocks
Snapped a new pic of mine tonight:
BCM Middy upper
ML2 in a LT mount
Troy rear sight & sling
Shortened Noveske Afghan. It’s my wifes (9x19 on these forums) and the most accurate rifle in our house.
GotM4 that is bad a%*
Here’s a couple…
Ok, just getting switched on to the whole mid-length thing. A couple questions…
Nitrox, can you throw out some data on your build? It looks like a non-16" barrel, can you confirm?
Jeff, is that dremel work on your TD rail covers? If so, did you have any particular method??
Thanks…
I use a hack saw and a miter box (at least that’s what I think it’s called). Helps cut them straight, I then use the sanding wheel on a dremmel to smooth out the rough edges and take off a little more material if needed.
Hope this helps