I’ve made the decision to upgrade to Magpul’s CTR stock, but I’m not sure if I have a milspec or commercial buffer tube. BM Patrolman’s Carbine. Anyone know which I need to order?
probably commercial. do you have a caliper? 1.146" is milspec, commercial is like 1.15 or 1.16 or something
Bushmaster, DPMS, Olympic, & RRA ------ Commercial Diameter
Colt, Noveske, LMT, Stag, S&W -------- MilSpec Diameter
Those I’m pretty positive, not sure about any others.
ETA: MilSpec is 1.15 while Commercial is 1.17 but nobody ever has a set of calipers. Where’s that danged Magpul PDF when you need it…IIRC, Commercial tubes aren’t perfectly perpendicular on the rear but have a negative pitch on the end - not positive however.
Yeah, commercial tubes are typically slanted on the rear. Milspec aren’t. Recently read the CTR instructions and that’s what it said.
Most likely a commercial, the OD is larger on COMM tubes & as also stated before, on alot of them in the back there is a negative pitch from top to bottom.
aww, man- essential home-gunsmithing equipment. you can get a General for like $15 at Home Desperation
Discussed here too.
LMT is mil-spec if you have/had a SOPMOD stock on it originally. Otherwise, it’s commercial.
bushmaster has SOPMODs?
Are you saying that if an LMT comes without a SOPMOD stock, it’s on a commercial tube??
LMT does not use commercial tubes.
Then I would have to measure mine. I have an LMT without the SOPMOD stock and I was told it’s a commercial tube. Is measuring the only way to tell? I was getting ready to order a commercial CTR stock. My apologies if I’m wrong.
EDIT: My apologies, LMT is mil-spec
Just a word of caution. There are some 4 position commercial tubes (unknown manufacture) that are not slanted in the rear and one must look at them closely to differentiate them from the MILSPEC tubes. I was given four of them (here in country) and the MILPSEC size stocks would not fit. But, since you stated the it is a BM carbine I am 99% certain that it is a commercial tube.
If I could adda a question? Which one is better?? I bought a CTR and got it in MIL assuming MIL is better. Besides the dimensional and angle differences is there any preformance differences?
The primary difference is the method of manufacturing and the actual strength difference is marginal.
If you already have a commercial tube and a commercial stock is available, I probably wouldn’t go out of my way to replace it.
If however I had the tools available and was an anal-retentive nut who just has to upgrade everything, I probably would. Sometimes it just feels good to scratch that itch.
My LMT defender lower came with the standard M4 style stock, and it is most definitely a Milspec receiver extension, and wears a Milspec CTR currently.
You ought to read the thread on Comm vs. Mil spec R.E. write up here. I can’t remember who wrote it, but it contradicts your assertion.
I’d go out of my way 8 times over to get that commercial crap off of my gun.
the only commercial buffer tube i would use would be the ace m4 7 tube, that things beast
Sometimes you scratch that itch and end up with shit all over the place though…
![]()
J/k… I’m the same way.
Just to make clear… Any stripped lower, including DPMS and other “not as great” brands will accept a mil-spec tube, right?
From what I’ve read is sounds like DPMS, etc. comes with commercial tubes if you buy complete, but if you have a stripped lower you want to build, a mil-spec tube will work. Is this correct?
Sorry to revive a month old thread, but I figured it would be better than starting a new one for this one simple question.