Can someone provide me with a video link or some pictures showing how to change out my extractor spring and o-ring? Thanks!
can you field strip the weapon?
rundown…
pop out takedown pins, remove upper from lower
pull charging handle and bolt carrier group out of the rear of the upper
use a pen or pocket knife to pull the little hook shaped pin from the side of the carrier
pull the firing pin out through the middle
rotate the cam pin (rectangle on the side by carrier key) and pull free
pull bolt from carrier
push pin through extractor, remove extractor
pull off the old spring, install new spring
assembly is reverse of disassebly
Push the pin out of the extractor and pull it out of the bolt. Then use your fingers and pull the spring out.
Take the extractor insert and insert it into new spring (in the fat end) and put the spring over the hole in the extractor (fat end goes into the hole). Take some needle nose pliers (or something like them) and press the spring into the hole.
Re-installe the extractor into the bolt.
C4
Thanks Gents! I wanted to verify that my new M&PT had a 5 coil spring, it didn’t. It does now!
Very few BCG’s come with a 5 coil spring (FYI).
C4