Glock Ejector

Ok, I have a question about my Glock 19.

I went out today to put a few rounds down range and run a few drills. Afterwards, I broke it down to clean and inspect. During the inspection I noticed something that I have not noticed before. I am pretty sure that I would have seen this had it been there before, but I dont see how putting a couple hundred rounds through it today would have caused this.

Now, with all that said, I noticed that my ejector (not an expert so I am hoping I am calling it right) is bent towards the middle of the gun. I broke down my other Glock and noticed that it’s ejector is straight as an arrow. Is this something that I should be concerned with or is this ok? And is this why my brass goes all kinds of crazy directions??
~D

Ejectors in a Glock are caliber-specific. To my knowledge, all 9mm ejectors have that bend. It’s part of the design.

That’s perfectly normal and how your Glock was built. You didn’t do that shooting any ammo.

Gotcha. That explains why it is different in the 22. I guess it is just something I havent noticed before. Thanks guys.
~D

That’s how my 26 looks.

no way man…thats not right. you need to get rid of that as soon as possible due to the possibility of a kaboom.

i will email you with my shipping information and i will dispose of it properly.

by shooting it until it crumbles into pieces…

its fine btw.

No worries man, mine is exactly the same :slight_smile: