AXTS A-DAC 10 lower (7.62x51mm)

[axtsweapons]

Not exactly. The takedown pins will line up, but the cut at the rear of the MA-TEN upper is angular, whereas the cut at the rear of this lower is radiused. So, there will be a gap between the upper and lower.

You are correct in saying that the prototype would fit the MA TEN but leave a gap. The prototype was only made to fit a DPMS upper because that is all we had on hand just before SHOT show.

We are currently designing a billet upper that will have the angled SR25 interface and the AX762 lowers will of course be updated to this style as well to create a matched set. In theory the production AX762 lower should fit any SR25 pattern upper ( MA TEN included) although we cannot garuntee it will fit other makers uppers due to their varying tolerances. The AX762 upper lower set will match up perfectly in every way in terms of fit, form, and function.