AXTS A-DAC 10 lower (7.62x51mm)

[axtsweapons]

very nice. what is the price for the finished lower as shown?

Wolfen,

The AX762 lowers that we showed at SHOT were prototypes we completed just in time for the show. They have to be thoroughly tested before we go into production. During this testing phase we will also be exploring more cost effective ways to manufacture the custom steel parts that go into the lower. The prototypes were all machined from solid tool steel which is quite expensive.
All that to say I cannot answer your question on price right now. I do have a pretty good ballpark but would not want to have any unhappy customers before even selling a product if I am off.

[wolfen]

Wolfen,

The AX762 lowers that we showed at SHOT were prototypes we completed just in time for the show. They have to be thoroughly tested before we go into production. During this testing phase we will also be exploring more cost effective ways to manufacture the custom steel parts that go into the lower. The prototypes were all machined from solid tool steel which is quite expensive.
All that to say I cannot answer your question on price right now. I do have a pretty good ballpark but would not want to have any unhappy customers before even selling a product if I am off.

gotcha, no problem. until you get into production it is hard to figure costs.

[fmiq]

Worst case delivery date on these

[axtsweapons]

Worst case delivery date on these

All I should say at this point is sometime this year.

[MookNW]

I have never been so eager to bankrupt myself. Looks awesome.
Not familiar with the dpms /sr-25 pattern, will this lower fit the ma10 upper from mega?

[caporider]

I have never been so eager to bankrupt myself. Looks awesome.
Not familiar with the dpms /sr-25 pattern, will this lower fit the ma10 upper from mega?

Not exactly. The takedown pins will line up, but the cut at the rear of the MA-TEN upper is angular, whereas the cut at the rear of this lower is radiused. So, there will be a gap between the upper and lower.

[Nefarious79]

surprised the billet lowers dont have the 68 degree selector markings but then again they are prototypes arent they...maybe next week I'll get around to putting in my pre-order for an Adac-F lower really like the idea of a 45 degree selector..the bolt catch mag release integration is just icing on the cake.

[axtsweapons]

Not exactly. The takedown pins will line up, but the cut at the rear of the MA-TEN upper is angular, whereas the cut at the rear of this lower is radiused. So, there will be a gap between the upper and lower.

You are correct in saying that the prototype would fit the MA TEN but leave a gap. The prototype was only made to fit a DPMS upper because that is all we had on hand just before SHOT show.

We are currently designing a billet upper that will have the angled SR25 interface and the AX762 lowers will of course be updated to this style as well to create a matched set. In theory the production AX762 lower should fit any SR25 pattern upper ( MA TEN included) although we cannot garuntee it will fit other makers uppers due to their varying tolerances. The AX762 upper lower set will match up perfectly in every way in terms of fit, form, and function.