Can anyone give me the width of the XS, and Meprolight tritium FSP’s???
Hell, if anyone has the width of the Trijicon model, that would be nice too.
I have checked numerous websites, as well as the manufacturers sites for XS and Mepro, and no one lists the WIDTHS of these FSP’s…
A stock Colt OEM FSP measures .070" thick, and I think this is TOO thick already.
I have HEARD that either the XS or Mepro are the same thickness, or just barely thicker in width, but I know I read somewhere that one of them is much thicker.
Can anyone give me some solid specs on width???
Thanks guys.
Our (XS) tritium stripe front sight (we make a standard and big dot tritium front sight as well) measures .106". Our stripe is probably going to be the biggest one on the market. The others are likely to be smaller, but only by a small fraction. Anyone that makes a tritium front sight has to build it within the Nuclear Regulatory Commision’s regulations. NRC stipulates that tritium sights must have .020" of steel surrounding the tritium vial. Hope this helps you out.
Thanks Joe,
Yes, I finally found the XS Tritium DOT front sight, and the Brownells catalog says it’s .080" wide. This is MUCH MUCH better than the .100" for tritium stripe.
I think IF I go with one, it will be this smaller tritium DOT.
Thanks for chiming in…
Brownell’s catalog is incorrect. I’ll have to call them about that. The standard dot tritium front actually measures .140" wide. It is actually BIGGER than the stripe.
Oh wow,
That’s not good to hear.
Oh well. Thanks for letting me know, and saving me the hassle! I would have eventually ordered it.
I’m just not big on FSP’s that are any larger than the OEM Colt FSP.
In fact, I prefer one that is smaller…
It depends on the situation. For 3 gun, I prefer a .050" national match FSP. For a general purpose truck gun, I like our standard .080" white stripe. If I were doing nothing but kicking in doors, I would prefer our standard or big dot tritium. When possible, configure your gear for your environment.