What Paratrooper Stock parts do I need for 5.56mm FAL Conversion?

Want to convert my 5.56mm IMBEL FAL to a paratrooper folding stock model. It currently has the humpback stock. What parts do I need from DSA to fully convert it over to a PARA model. As far as I know, my upper does not have the Para cut.

The big question is will the 5.56mm bolt fit in a standard 7.62 NATO Para bolt carrier.

It will fit and operate in a 7.62 NATO bolt carrier. I had to swap out BC’s a few years ago with an IMBEL and it fit fine. I know there’s a PIC in the FAL pic thread that has a 556 Imbel owner with a paratrooper stock.

This out to get you where you want to go…

http://www.dsarms.com/US-Made-FAL-Paratrooper-Stock-Assembly-----P120USSETN/productinfo/P120USSETN/

The steel parts are going to be phosphated and the aluminum parts will be grey anodized, so you’ll want to gunkote or duracoat to match the finish of the rest of your SAR-4800.

Thanks Temp! I also need to figure out the 922r parts. Just the stock kit has 3 parts, the SAR4800 uses US mags which is 2 parts…what other 2 parts should I change out if I’m going to keep my original, foreign FCG parts?

Handguards and pistol grip would be my two choices.

The 5.56 FALs use STANG magazines, so just use a USGI M16 magazine and that should meet the parts count you need for 922 (r)…

Just my .02

B