Has anyone used a Ti-Rant 45 on a 9mm or .40 cal pistol (I’m thinking Glocks, specifically)? Does it work ok? I’m considering a single suppressor solution for my Glocks to start off with, then in the future I can buy the caliber specific ones if necessary.
Hmmm. Short answer…it depends. Obviously the round will fit down the tube and will be suppressed more than without a can but how effective will it be? There’s plenty of room in a .45 can for gases from a 9 mil to escape and .40 cal is a pretty hot round compared to a .45. Also, will it cycle properly? Don’t know that either. The boosters are tuned for the round to cycle the weapon properly so not sure how it would react to another round.
I know that didn’t answer your question but it’s some of the factors that have to be considered.
Ready, you make good points, but let me speak from experience-
RAM, it works well. short answer.
Long answer is it’s very similar to running a 30 cal can multi-caliber on a 5.56 weapon.
Performance will be a few dB louder than a dedicated caliber-specific can (usually around 3-6 dB). The loss of efficiency due to the oversized bore is mostly compensated for by the larger volume. Due to the booster system, it’ll run perfectly on full and mid-size handguns (i wouldn’t run it on a G26 though). It’s a good way to get the most “bang for the buck” out of one can.
That said, the downsides are- it’ll be noticeably louder than a dedicated can (still hearing safe though), and it’ll be a decent bit longer and heavier than a dedicated 9mm can.
Let me know if you have any other specific questions!