Upper wear concern?

Im gonna try to upload a couple pics of my upper. Its a 2A Armament light version. I run it with a Spikes lower. I’m shooting myself in the foot for not getting a matched set of either one. That for now is somewhat irrelevant.
Anyway there’s some wear right along where the BCG rides. As you will see, the upper part of the upper. Two questions, Is the wear normal? And is the location normal?
NOTE*…If the wear appears deep, it thankfully is not. I believe it’s mainly the paint, perhaps a minute amount more.
Thanx ahead for any insight. …Also, this gun so far shoots quite well, so no problems there. I just want it to stay that way…

M4CARBINE ROCKS.

I added more pics

Is the wear inline with the cam pin track or is it where the charging handle rides?

Can’t tell much by picture other than it appears to be the entire length of the upper. That would leave me to believe that you should check the front of your carrier for any thing funky. Should be a corresponding shiny spot somewhere. Maybe check that your receiver extension is giving the carrier a straight shot back as well.

My gut reaction is “It’s fine” but you never know. Any more pics?

Looks like where the cam pin rides, what is the approx round count on that?

My gut reaction is also to say “dude, it’s fine”.

Maybe I’m missing something???

Are you talking about the wear where the charging handle rubs on the upper receiver?

thanks for replies, I will get better pics up because its on both sides, more on one side but both sides, when I get a min, I will get better pics up.

thanks again

Subject matter expert may correct me on this, but I’ll give my completely worthless opinion anyway.

That wear looks completely normal, and it appears on surface areas that it should appear on. You will probably notice wear areas on the finish of your bolt carrier in the corresponding locations which is also completely normal.

The bolt carrier has simply burnished through the anodizing inside the upper from reciprocation. Nothing to worry about that I see.

My advice is to keep it well lubricated, feed it good ammunition, and shoot it frequently. Shoot it for fun, shoot it to train, take classes with it, take it to matches. Clean as needed, and re lubricate. Rinse and repeat as your budget allows for good ammunition.

Round count?

Do you even lube bro?

That looks like a ton of wear, honestly. Easily in the 10-15K round area. I have 5K rounds on my DDM4, and it looks nothing like that.

I’m with WS6. I have 9k through one of my rifles and it doesn’t have that type of wear. Neither does any of my other rifles with between 3-6k rounds. But I run my rifles wet.

Looks excessive to me.

If you’re running an enhanced BCG with a billet upper it’s possible to have this occur from such a tight fit. How easily does the BCG move when you cycle it by hand? I’ve ended up moving a certain E-BCG to a forged upper simply because the tolerances were so precise on it and a billet upper, that it actually had “sticktion” in its range of travel.

First world problems…

I definitely want to second the comments suggesting that the depicted wear looks excessive. Looks like that upper has seen multiple thousands of rounds. How does the carrier ride? Does it feel like its binding anywhere when you hand cycle the rifle? Also, i disagree with the assertion that the wear patterns correspond with where the cam pin rides. Though its somewhat difficult to tell from the pictures, it looks like the wear is due to quite a bit of friction between the top two “rails” where the carrier “rails” and the upper “rails” touch…if that makes sense. It may be just fine, down the road, but I’ve never seen such extensive wear, in that area, in a new upper.

THANKS FOR ALL THE REPLIES, I tinker a lot and that upper has been with several bcgs. so with an expensive upper, I will stick to 1