I was following the online instruction to install the APEX trigger kit for M&P. Everything was going well and smooth until I push out the sear pivot pin and realize I had the older version with the smaller hole for the spring and plunger.
In the video, the person said they “strongly recommend” getting the newer version to help to improve the time for the sear block to catch the striker.
So my question is if I use the old one and this “fail to catch striker” problem occur, what would happen (is this the same as the AR hammer fail to catch onto the trigger?) Also where can I find a newer version with the larger hole size? Do S&W sell them separately?
Also I found 1 (or maybe 2) parts unused after the installation. Picture below. I know the middle one is the new sear spring and the thing on the left is the sear plunger? What would be the spring on the right be?
I believe a dead trigger is the very rare but possible malfunction with the smaller hole sear housing. I believe that this is more of a problem when using the Foward Set Sear and Trigger Kit. I run the DCAEK + RAM in 3 pistols with the smaller hole and have never had any problem with a combined 20,000 + rounds. If it really bugs you, you can send you sear housing to Apex and they will enlarge the hole, or you can buy a separate sear housing online.
Both of the springs in your picture are sear springs. Use the smaller/thinner one (middle object) for you pistol’s smaller hole if you decide not to change out the housing or enlarge the hole.
In you picture, the object on the far left is the tool used to assist your replacement of the trigger assembly. Is use is detailed in the videos towards the end. You will use your factory sear plunger for all af the Apex DCAEK upgrades at this point.
Ah I see, I am installing the APEX FFS. Where can I buy a separate sear housing (Midwayusa’s expected delivery date is around end of Jan)? I just finished putting everything together, dry fired, and its fail. LOL, trigger bar wont engage sear block.
There’s a “candy cane” in there that engages. If you get a small flat head you can open it up a minuscule amount and it should fix that. It is possible to open it too much though. You’ll have to work with it until you find the right amount.
That’s the part you want. It’s a whole new sear assembly, ready to just drop in and go. It has the larger sear spring and plunger already in it, it’s what I bought when I installed my FSS. Keep in mind though, this unit comes with the internal lock and mag safety. Both can be removed, the IL very easily, the mag safety with a little more finagling.
One quick question, with the new sear housing, did you have to replace it with the new sear block like showed on the APEX video? Or is this new version already ready to go.
You have to replace the whole sear block itself. The larger sear spring and plunger is part of the block, so the whole thing has to go in. On the plus side, the new block from Brownells has everything in it already; the sear, plunger, plunger spring, etc. So all you have to is take out your old sear block with everything in it, and then just drop the whole new assembly from Brownells in. Just be aware, again, that the block from Brownells has the internal lock and mag safety in it.