***SOLD*** Semi Custom G34

SPF

For Sale (Texas)

Semi Custom Glock 34 Gen 3

I have been a Glock armorer since 1998 and unless otherwise noted, I did all the work to this gun.

I purchased a complete Glock 34 upper from GlockTalk in 2008ish to compliment my G35. From what I recall, they listed as hardly shot. It was very clean and I did not shoot it till I bought a frame as I ended up selling my G35.

I shot the G34 upper very little. I purchased a brand new factory G17 receiver in 2011 on the 10-8 Forum. I hardly put any rounds through the G34 as I mainly shot 1911s. This receiver has a smooth face trigger and a Glock minus connector. The G34 upper is all factory and pre MIM and the extractor is very nicely machined.

I installed a 10-8 rear .156” notch and 10-8 brass bead .230” tall / .125” wide front sight.

If I had to guess, the upper has less than 500 rounds through the tube with the frame around 250 -300. So very low round count. The G34 is accurate and reliable. No brass to the face.

I decided to resurrect the G34 project and recently sent the frame to Polymer Refined in San Bernadino, CA for his complete texture job. Mag release area relieved, high front strap, finger grooves removed, thumb textured depressions and very grippy textured pattern. Feels very good non slip grip. The Grip Force Adapter was textured to match the frame and if you don’t like the GFA, its textured underneath, so all you will need is a shorter pin if you remove the GFA.

I followed Grant on the M4Forum technique for a Glock action job and have a very smooth and clean breaking Glock trigger.

I added a Vickers Mag Release and Vickers (TD) slide stop. Jentra Butt Plug and it will come with one factory Glock 17 round mag.

The slide does have a few minor handling marks but overall, its in very nice condition and the usual wear areas do show some use, but it is also evident that its not heavy use. There is markings on the left side slide serrations. I must have bought it that way because I don’t recall doing anything that would have caused it. Its hard to see, just giving full disclosure.

My next goal was to send the slide to either WOTG or ATEi for front serrations but this project went stale due to major purchases coming up.

After looking at what I need to thin up, I have made the hard decision to let this piece go. I would like to keep it and will regret it later, but I don’t have a need for a G34 and I am issued a G17 and G19 from work.

Remember, this set up is a 2008 Gen 3 Upper with a 2011 Gen 3 receiver.

Serial Number prefix on the upper (matching) is LLSxxx.

Serial Number prefix on the lower is TDYxxx.

I have over $800 in this set up.

No box, no papers…gun and 1 high capacity mag.

no trades please.

US CONT ONLY

No sales to states with red tape (sorry)

FFL to FFL

$600 shipped USPS priority mail with insurance

USPS MO preferred or Paypal plus the fee (no checks)

please know your gun laws before you bid

Also listed on GB.
thanks for looking.

Lower the price.

thanks for looking

SPF**