shaving part off Magpul BUIS

I am curious if anyone has shaved the left release tab on the rear sight?

When pulling the charging handle back, my finger rubs against the tab and is a bit annoying.

But I am curious though that if I do shave the tab off, it could cause some type of tension difference and not open that same as it does now…if that makes sense?

As soon as I read the title, I knew what you were gonna say cause I was thinking the same thing. I have looked it over and see no reason why removing the tab would affect anything. I am getting a BCM Gunfighter charging handle so I won’t do it now. But I say if it works for you, go ahead.

I’ve seen it done.

It works fine simply by pressing on the top of the “front” half of the BUS, rather than on the tab.

Less than 3 minutes with a Matco bastard file. I’ve done every rear MBUS immediately after getting it.

Ek

so the consesus is, shaving the left tab will not affect how the rear sight flips up by pressing the right side tab?

I just dont want the “mechanics” of the sight to be different…that’s why I am asking here.

Not a problem at all dude. You’re ‘over thinking it’.

Just grip it an’ rip it! :big_boss

Ek

cool. Thanks to everyone for the quick replies.

I had the same thoughts about the front sights left side tab. My light was hitting it and not letting it lock back down. Probably would have been cheaper to file it off than to get a spacer but I hated to work on a brand new sight.

I cant believe I didnt think of this. Thank you.

I did it on the front MBUS on a prior upper to clear a scout light that was blocking the deployment of the sight. Does not hurt the sight at all and it came out so clean, I shaved off the other side for a symetrical apperance.