I bought a CAI Golani knowing full well it would have issues.CAI stuff is mediocre at best.I priced out a Galil kit and an ORF Galil receiver and it was cheaper to go with the 599.99 J&G .
I generally like to build from the ground up but was feeling lazy and felt I could correct CAIs build mistakes and the known ORF receiver issues.
The rifle arrived and had piss poor finish overall.The stock had some kind of cheap paint that flaked off.The synthetic hand guard had seen better days and was bead blasted to make it quasi presentable.The top cover was a PITA to remove and impossible to put back on without a rubber mallet.
Firing a variety of .223/5.56 ammo it experienced failures to extract,eject,double feeds.The provided 35 round mag was dented and had deformed feed lips.I secured some “better” but tired 35 round steel mags and some new Orlites.Same thing and then I had a case rupture leaving the brass case in the chamber.This CAI gun is the “F” marked high 3xxx serial range.
I removed the stuck case using the Brownells Cerrosafe method,slicker than cat snot.
Found and corrected problems:
#1 Gas piston secured poorly by undersized roll pin.Correct pin utilized.
#2 Numerous burrs inside receiver that were removed by hand.File and stone.
#3 Bolt carrier did not lock up correctly.Contacted right side of receiver but .070 of space on left side.Bolt carrier fitted.Extensive fitting of receiver near the breach area and left and right sides of lower.
#4 lapped bolt to fit receiver.
#5 fitted top cover so it can be removed and installed by hand.
#6 head space and chamber cast show these cut for .223 not 5.56.Awaiting 5.56 reamer.
#7 will refinish with Dura-coat .
Test firing at this point shows to use .223 ammo and that the steel mags need new springs and some are dinged and dented.Orlites worked fine.Fired cases are like those from other AK based systems,dented and violent extraction.
Moral of the story.Want a Galil?Pull your pants down and say ahhh and buy IMI.Always build kits from the ground up instead of dealing with others messes.The ORF receiver has issues but can be made “serviceable”,alot of fitting will be required.The metal seem hard but the ejectors seems a bit soft,time will tell.