Ever since I’ve gotten my Primary Arms 2.5 CQB sight, I’ve been curious about mounting a red dot of some sort on it. I’ve been somewhat discouraged when reading about reliability of various Trijicon red dots, and so held off on it until I heard about the SeeAll sight. This seemed to fit the bill, so I decided to order one and mount it. This is what it looks like:
I’ve literally just mounted it, and have had no chance to use it - however it seems like it could have potential. The sight is about as low as it can get, there is no battery to worry about and I think that I could get used to the motion required to switch from magnified scope to the “red dot”. Hopefully I’ll be able to take it to the range in the next few weeks and get a more hands-on evalutation
I am not a fan of piggybacking optics on top of each other. Offsetting to the side is more my preference, but to each his own.
As for this “red dot”, I am not sure I get it. It looks like a very odd optic. How do you tell if your eye is directly in line with the aiming point? Can it be calibrated? Is it a colimated/holographic sight so that the eye being off-center doesn’t result in you aiming way off target?
No idea what to make of this.
A little bit. So far, my sense is that the sight is usable - I fired several rounds from about 15 feet at the target, and the POI was pretty much where POA was. As far as acquisition speed, I’d say I was about the same as I would’ve been with irons. I’m not comfortable with the chin weld necessary to acquire a target - this might go away with more training, or it may not. I’m thinking of getting a cheap set of 45 degree sights and seeing whether I like that set up better.
Yes, but it has the same limitations as any other red dot sight (Aimpoint/Eotech, etc). If your eye is too far off the bore, eventually the floating reticle is obscured by the side of the sight. Same here.
And it appears that it has to be lined up in both planes. May as well use offset irons and get away from the spray and pray aspect of having to give up cheek weld to use the top mounted sight.
I think that’s a bit unfair. Like I said, at the distances I need this sight to work - i.e. around 0-50 feet- it looks like it would work just fine at putting bullets where I want them to go. Anything further, and ACOG would work just fine. My main concern at this point is with speed of acquisition, not with accuracy.
