I’ve got a timney drop in trigger for my ar, and when I remove the grip and try and remove the safety selector, it doesnt seem like it has quite enough clearance to simply slide out, as I’ve seen in some online video demo’s. So it feels stuck.
On some online videos of safety selector replacement it seems like the trigger is in, pins and all.
do the trigger pins have to be removed before it will slide out, or can I just be careful and punch out the selector?
I’m new to the ar game, but trying to learn my way around the platform, so I find myself looking for online resources, but obviously want to understand the setup before I go breaking things.
Remove the pistol grip and if you carefully inspect the receiver you will see a small pin underneath the spring that is in the pistol grip. This must be removed and the selector will come right out.
Re-installation requires you put the selector back in. Place the spring into the hole in the pistol grip. Place the “pin” (sharp nose in) the hole in the receiver. Carefully place the pistol grip back on the receiver with the spring going into the hole that you just dropped the pin into. Screw in Pistol Grip. “Voila!”
Thanks for the reply. Yeah I’ve pulled off the grip and pulled the spring and pin out. But when starting to pull out selector it looks like it’s just brushing up against part of the timney, preventing it from pulling out smoothly. I was wondering if the timney is slightly different from the stock, requiring a slightly different disassemble procedure. Or If I just need to muscle it out.
i wouldn’t muscle it out… i’m totally unfamiliar with the timney triggers- can you just press down on it while you pull the selector through? have you tried cocking the hammer? releasing the hammer?
yeah I’ve tried all positions, and tried pushing down on the area near the selector, but no go. figured it wouldn’y hurt to ask before removing the pins. With the timney, the pins are held secure by a few small screws that are covered by part of the spring, so just wanted to check before noodling in there to get them out.
It’s been a couple of years, but I put a Timney in my CDD. I love the trigger, but the detent is so much softer now; barely a click. You’d think it was the pin, but that has not solved the issue.
This sounds like an “over adjusted” clearence screw. If, when the trigger was installed… the installer over tightened the cap screws that “snug” the trigger pack then it tends to be a little high in the “tail”. IE, the rear ,towards the stock, part of the trigger body that goes under the safety.
The fix, if you want to call it that, is simple. just back the two adjusting screws out 1/4 to 1/2 turn per screw until your selector slides free.
This is a pretty common mistake made by loads of different installers. It doesn’t make the company or the person who installed it a stupe… just human.