Remington 700 AAC-SD 308

Just picked up this 700 in a Black Friday deal. It’s in 308, 20 in barrel, 1-10 twist. What MOA scope rail should I use?

One question is how far are you planning to shoot?

I’ve got a 20MOA Nightforce rail on mine (same gun), but got that for two reasons. First was that I was planning on stretching that gun out to as far as a 308 can reasonably go and (2) a buddy had that for sale for cheap when I was looking for rings and a rail. If you’re only looking at shooting shorter ranges, then I’d imagine a 0 or 20 would be fine.

get a 20, 308 needs it.

I have a Badger Ordnance 20 MOA rail on mine.

As kind of a precision rifle novice, what does “20 MOA” refer to?

The scope base is angled with the idea of having he zero with the reticle as near to the upper extent of its travel as possible. This leaves the full amount of travel available for dialing for bullet drop at range via the turrets. 20MOA is an angular measurement that tells us how much the taper is on the base and how much more elevation travel we can expect.

Sent from my iPhone using Tapatalk

Thanks. Is such a base better installed by a gunsmith or can the shooter do it himself?

Be sure to Google and read up on bedding scope mounts - it’s really a must-do on 700 receivers.

The Nightforce mount and rings are really nice gear. They have a one piece mount (base and rings combined) that is worth looking at.

Sent from my ZTE A2017U using Tapatalk

You can do it easily. “Bedding” the base just involves a shit ton of blue locktite underneath it where it meets the receiver. Then a wheeler engineering or similar torque wrench to take the screws to 15-18 inch pounds. Badger Ordnance provides the instructions on their website. Then just allow the locktite to set for a day or two. Wipe the excess locktite up with a paper towel before it sets obviously.

Frankly it’s a good process for putting rails on most receivers too. 10/22’s etc…

Sent from my iPhone using Tapatalk

Is this necessary if the rail has a recoil lug?

It’s a good idea. It has little to do with bracing the base through recoil, and more to do with maximizing the surface area and consistency of the contact and pressures applied to it by the receiver.

Sent from my iPhone using Tapatalk

Just curious what kind of deal you got on the rifle?

$590.00

Wow. Not bad.

On my 700 ACC I just used a Warne 2 pcs base and Low Warne QR rings with a Leupold 3.5x10 scope.
I did order a HS Prec stock PST 086…that factory stock has to goooooo. I got mine Friday also.

I was looking at one of these AAC-SD’s at a local store. They also had a Howa 1500 with the 20 inch heavy threaded barrel. Both had (I think) the Hogue stocks. Not to digress too far, but how does the Howa compare overall with the Remington? Howa seems to have a pretty good reputation but it’s not exactly a household word.

Suggest go with Remington you have so many aftermarket items for the Rem 700

That was my thoughts when I bought mine. If you are going to try something different, seems like there is more support now for Tikka rifles than before (unless I am imagining things).

Sent from my ZTE A2017U using Tapatalk

I took some bad interweb advice and bought a standard base when I got my .308 rem 700. The 20 MOA is not only necessary, it puts the scope closer to mechanical zero… which means you won’t run out of “come up” when you get to 1000 yards and beyond.