Rebuild and BCG no longer closing to barrel

Hey all thank you for your help.

When releasing the BCG, it gets hung up about 1/2" from the ramps, requiring me to press the BCG forward with my thump to get to the ramps. The assist doesn’t close it.

I recently swapped out:

  • stripped upper to a Noveske VLTOR upper
  • BCG to an unknown brand as part of a trade to Iraqgunz as my other one malfunctioned

What are a few things I could try to create full travel for the BCG?

The rifle is cleaned and lubed with CLR.

Thanks
Bear

Is your gas tube aligned?

Gas tube.

take the bcg apart and slide the carrier itself into the upper to check for proper gas tube alignment. if it strikes, you either need to check gas block alignment. if block alignment is solid, you may use a flat head screw driver to tweak the tube left or right. if the key is striking on the top or bottom, that means the bend in the tube is off and youll need to replace it.

Thanks guys that was it. Much appreciated.