Range report 18 inch Rogue Hunter, Geisselle Three gun Trigger, Caspian 38 Super Comp

Well I took the rifle out today and zeroed it with the irons and two optics. The primary being the Swarovski Z6i and the other being my Burris Full Field II 6.5-20 x scope that I use for testing accuracy on AR’s.

I then fired it over my Chrono graph using my new three gun load 24.1 grains of Vitavory N140 with Federal Match Primers Lake City Brass and Sierra 77 grain Match King bullets.

The velocities were as follows. Temperature was 40 degrees.

  1. 2568
  2. 2591
  3. 2605
  4. 2600
  5. 2591

Average 2591
Spread 37
Power Factor 199.5

I then grouped it at 100 yards. First with the Swarovski on 6x. I had to get used to the new Three gun trigger. It caught me off guard a few times and I fired a bit before I wanted to hurting a few groups. The one in the upper left the most. My average with the Swarovski for 5 shot groups was 1.64 but each group got better as I got used to the trigger. My last group being . 926. I love the trigger its great for snap shooting but I am used to a two stage system and I will have to retrain myself on the single stage system.

I then mounted up my Burris 6.5-20x scope. I use this scope for load testing for accuracy with my AR’s. Here are the groups I got.

I covered the center because that was shot with factory 75 grain 5.56 TAP ammo and it was 1.166. The other groups that are shown were all shot with my reloads. The three bullets in the center of the lower bar where from me sighting in at 100 yards. It is not a group. Anyway the average was .94 for 5 5 shot groups. The best group was my first at .421. These were shot on 20x.

After the accuracy testing me and a friend shot the rifle on my departments rifle qualification course. (total of 60 rounds)

I loved the trigger on the practical work. It was easy to break the shots off hand quickly while staying on target. The rifle is light and easy to maneuver. Its balanced well. I love this gun. I am taking it out to Kenai’s rifle range tomorrow to test the bullet drop on my Swarovski out to 500 yards. The Swarovski was awesome as well. Nice clear glass and the bright dot is like shooting an |Aimpoint.

No malfunctions of any kind during this first outing with just a few hundred rounds fired. Recoil with the JKC titan comp is non existent.

I also fired my Open Pistol that I got from a friend for a great price. It’s a Caspian in 38 super comp. My reloads with IMR 4756 averaged 1385 fps with 124 grain FMJ ammo. The power factor was 171. It still has muzzle jump. But the gun was very accurate for me. I shot this 5 shot group at 20 yards in about 7 seconds or so.

The gun also ran flawless. My first outing with this gun was not so happy. Just 15 rounds into sighting it in one of the accu rails broke. I sent it to Accurail to have some new rails fit and it arrived back to me last week. Now I am very happy with the pistol. I only paid 1000 for it.

I will write more up tomorrow hopefully.
Pat

Range Report 11-23-10
Gun Tested Noveske Rogue Hunter 18 inch.
Optic Tested Swarovski Z6i BRT.
Trigger tested Geisselle Three gun Trigger. Single Stage.
Weather conditions. Light to moderate rain and fog. Temperature 39 degrees. No wind.
All paper targets shot at 200 yards.

I went out to Kenai to try my new three gun rifle at longer ranges. I planned on zeroing the rifle at 200 yards and then testing the bullet drop marks against what the ballistics program on Swarovski’s sight said it would do.

My first group fired sucked big time. I thought something was wrong with the gun and it turns out there was. I had 3 shots on the top of my target that were in a 2 inch group but I had 2 that were 8 inches below. A friend of mine looked over the gun and noticed that the modular rail I had installed at the end of the Troy fore end was contacting the bottom of the gas block. I removed the rail and started over. The next group was much better but still disappointing.


And then another one that was not too bad but I am not sure if I put one bullet through the same hole or if I missed completely. There should have been 5 rounds on target.

Then I thought perhaps my reloads were not up to snuff so I tried a box of Federal 77grain match loads. This proved a touch better.

This group was low because my handloads shoot a bit faster.

I dialed in for the match ammo and then shot another group which was a bit better.

I knew my reloads were accurate in my Larue Stealth so I decided to shoot it as a control.


The group was acceptable but not as good as it normally does. Thinking that I was having a bad day since my back was killing me from wrestling with a drunk last Friday I had my buddy shoot my gun (Noveske) and his group was worse.

I thought part of the problem may have been me not being used to the new single stage Three gun trigger from Geisselle. The trigger had a touch of creep and broke sooner than I was used to with the two stage Geisselle triggers in my other guns. So I put my Noveske upper on my Larue lower and fired a group with my reloads.

It was more in line with what I was hoping to get with this rifle. I found the heavier lower with the Magpul PRS stock made shooting precision groups off the bag easier when combined with the two stage trigger that was easier for me to control.

I was again happy with my Noveske and I knew that it was accurate I just need to get used to shooting a lighter rifle and this new trigger. Not sure if I am going to keep this trigger in this gun or swap it for one of my two stage Geisselle triggers.

The Swarovksi was awesome. The hold points were dead on to what the program said they would be. I was shooting steel targets at 300, 400, and 500 yards with ease. As the day started to get darker and when the fog really started to settle in I really appreciated the illumination on the Z6i especially when shooting at the white painted Ram at 500 yards. The clarity on the Swarovski was awesome. I love this scope.

FINDINGS:

I like the Troy rail but wish it were just slightly bigger around so I could mount the rail for the bi pod at the end of the rail. I had to move it back 2 inches when it gets in the way of where I like to grip the rifle. Not a big deal on a tactical class rifle but when I shoot open I want a bi pod.

I prefer the adjustable Geisselle two stage triggers to this new single stage three gun trigger for accuracy work. The jury is still out on rather I will prefer it for all around shooting. I need to work with it a lot more to make that decision.

Light rifles are a bit harder to shoot accurately at long range off of bags vs. heavier rifles. But lighter rifles are easier to shoot and carry over the long haul. I love the way the 18 inch Rogue Hunter balances and feels the way I have it set up.

Shooting in bad weather when your back hurts does not help to make tiny little groups.
I would definitely recommend the Rogue Hunter, the Swarovski z6i BRT to a friend. I would also recommend the Geisselle three gun trigger to a friend. It’s not a bad trigger for what it was designed for. I am just more used to two stage triggers.

What kind of compensator is that on your pistol?

Cool blasters!

I got the gun used I really don’t know what brand the comp is.
pat

That’s a VERY old compensator design by Johnny Lim of Limcat Custom. It’s one of the best pistol comp EVER designed, but a huge pain to machine (and Johnny’s got better stuff out now).

Send him your lower receiver and you he can modify the frame to take STI/SV mags which are way easier to find and less of a headache WHEN the Caspian’s go south.

Rich

How much does the mag conversion run? The main reason I got this gun was because I got a great deal. I paid 1k for it with 1 big stick and 2 smaller mags.
Pat

No idea on the cost. You’d have to contact Johnny at Limcat Custom. If you get it done, let me know when you need tuned mags.

Rich

A friend of mine looked over the gun and noticed that the modular rail I had installed at the end of the Troy fore end was contacting the bottom of the gas block. I removed the rail and started over. The next group was much better but still disappointing.

Thanks for posting that. Just looked and I have a similar pressure point on a 13" VTAC rail on my Noveske SPR barrel. The backing plate is just kissing the rear 1/8" or so of the gas block.

Accuracy has been very good - even out to 700 meters with my 77 SMK reloads (off a bi-pod). I don’t know if it will be a significant improvement or not, but I plan to find out.

I originally mounted the 4" rail up front and ended up using the rear portion for the bi-pod. A 2" rail in the second slot should work well for me.

FYI - It looks like there’s enough excess length on the end backing plate to modify it so it does not touch, at least on the VTAC version.

I shoot 77 Sierras for long range stages and have found them to be amazingly accurate in my Noveske barrels.