Acknowledging that I might be pursuing this due to misplaced priorities, I figure I’d share in case anyone else is interested.
It has been a struggle to keep my lightweight carbine light weight. It was going well until I realized that I truly need decent magnified optics to see past my finger tips anymore, but I managed to keep my “lightweight” carbine at just over 7 pounds with the use of a Leupold VX-R Patrol scope and a reasonably light weight (5.5 ounces) GG&G non-QD mount.
Though I depend on a Glock 17 and “Betty” (see link in sig section) as my primary HD weapons - both of which wear WMLs 24/7 - I have been resistant to add a WML to my carbine because…well…I’m trying to keep it light weight. That said, being 100% convinced of the utility of WMLs, how can I not have my carbine set up for one?
Based entirely on my own (and perhaps not-so-good) self advice, I decided that I would take the “detach it when you don’t need it” approach, which in my case I estimate to be about 99.9% of the time. Since the WML will most likely be detached before it even goes into the case on the way to the range, I figured I may as well go for as much light as I can without getting overly stupid about it.
So here’s the set-up: a Malkoff M61T MD2 in a Vltor off-set scout mount;

With 350 lumens through a TIR optic producing 12,000 lux at one meter, long run time, uber-quality construction and a lifetime warranty, the light is nicely spec’ed for weapon use. It’s also a really nice light for other (normal, hand held) uses. The switch is forward-clicky but is recessed in the cap and takes quite a push to lock it on.
The Vltor mount is working out nicely as well, placed on the top of the BCM KMR rail all the way forward (my Magpul offset BUIS only had to be moved back a few notches). The thumbscrews make attachment/detachment quick and easy, and a bit of black electrical tape on the inside contact surfaces keep the light from moving under recoil (and keeps the type 3 anodizing on the Malkoff pretty).
The light and mount together weigh 8 ounces, which compared to something like the Arisaka 300 is a bit heavy. But then again quick, tool-less mounting means the light doesn’t live on the rifle.
(PS - for a “permanently mounted” WML I’ve would have been all over the Arisaka)
Sighting imaginary zombies in my back yard in the dark with the Leupold set to 1.25X and the scope’s red dot turned on, the M61T MD2 provides plenty of illumination for target acquisition/identification all the way out to the edge of the woods about 50 yards away. With the light mounted in the 11 o’clock position, it does not enter the field of view even at the VX-R’s lowest setting.
Not wanting to stop there, I also have (on order) a Malkoff Hound Dog 18650 head, which will scorch the woods with 900 lumens and 29,000 lux. It runs on the same battery (a 3400mah Li-ion) and it’s just a matter of unscrewing the M61T head off and the HD 18650 head on. With that, it will be head shots on those zombies hundreds of yards away. The HD head is also equipped with Malkoff’s high-low switch, which entails unscrewing the head a few degrees from full tight to drop it back to about 30 lumens, perfect for taking the dogs for their final walk of the day (after I’ve shot all the zombies with it mounted on the carbine).
I’ve been told that a WML should remain on the weapon 24/7 but since I’m too stubborn to listen, I’m so far happy with this approach. I’ll post a few more photos when Gene sends me the Hound Dog.


