Looking for someone in Texas to pin and weld a muzzle breake and gas block. If anyone here is around DFW or preferably Wichita Falls and would do the work let me know. I would rather have it done somewhere where I wouldn’t have to ship it.
It will be a DD 14.5, DD low pro gas block, and a 1.5 BattleComp.
Can I ask why you are pinning the Battle Comp.
I’m not going to SBR the lower and I’m under the impression that I have to pin and weld it to a 14.5 barrel.
Just send it to ADCO in Ohio and have them do it. I wouldn’t trust any of the local smiths in DFW to do it right.
This.
I just got my 14.5 BCM upper back from ADCO last week. Was about a week and a half from the time I shipped it out to the time I got it back.
I had a Battlecomp 1.5 pinned/welded, a BCM low pro gas block pinned, and URX 3.1 rail installed.
I bet Ident could do a good job for you.
Did you send them the upper, gas block, barrel, and BC all separated or did you install the barrel nut, gas block, and the BC?
Ill be using the geissele rail so I thought I would slide the barrel but on first then ship the rest with it. I see that the charge for pinning the BC doesn’t include I stalling so I would basically have to install the barrel nut, gas block, and the BC.
Where are they located? It’s not on the sight.
Sent it in pieces with a list of everything that was in the box. Got it back as a completed upper.
Rockwall.