newbie question about changing barrels

I bought a new barrel with A2 sights for my AR and it does not come with a delta ring assembly. I plan to re-use my existing d ring for it. My question is, will I need to remove the A2 sight on the new barrel to get the d ring to slide down to the receiver? Or can I simply slide the d ring onto the barrel from the breach end? Thanks

You will need to remove the sight. Is the sight pinned or clamped onto the barrel?

That’s a good question. It hasn’t arrived in the mail yet. It’s a Colt SOCOM barrel. I’d bet it’s pinned if I had to guess. Thanks for your answer.

Should not need to remove the front sight - it assembles from the rear IF the barrel nut is in place - which I assume is the case. You’ll need a pair of snap ring pliers in addition to a torque wrench and a barrel nut tool (armorers wrench).

I would assume they put the barrel nut on before they installed the sight. You may also need a gas tube.

The delta ring can be removed over the breach end once the barrel is removed. The barrel nut is removed on the muzzle end.

If you end up needing to remove the FSB, I’d go ahead and get a good punch. You can find them at ACE hardware, or order one online. I got one at ACE in a pinch… specifically for driving out Colt taper pins. They can be in there tight. The punch you want has a concave tip that mates well with the round tip on the taper pin. MAKE SURE to drive them out in the right direction… driving the small end out, and the large end when reinstalling.

There are a few threads about taper pin removal. Here’s the first one that popped up when I did a search. Good luck!

https://www.m4carbine.net/showthread.php?41732-Removing-BCM-FSB-Taper-Pins

Thanks Gentlemen, I got my answer. This is my 1st AR build so I’m sure I’ll screw/scratch something up! But maybe I’ll learn something. Thanks again, best wishes

I assumed no barrel nut was in place. If the barrel nut is already on, you are gtg. I recently bought a barrel that came with an FSB but the barrel nut wasn’t in place. (Noveske) No big deal to tap out the pins though.

I just checked the description on Brownells again. It does come with barrel but in place (for some reason I didn’t think it did) anyways, thanks for the help. I’ll get some snap ring pliers and do my best not to scratch the hell out of it.

You’ll do fine. Have fun.