Finally got the new Colt 6951 9mm AR-15 to the range the other day. Long story short, I loaded it up, pulled the trigger, and CLICK. Nada.
Ejected the round, and had a light primer strike. Figured cheap ammo, and chambered a new round. CLICK. Nada.
Ejected and same story.
Knowing what I know about Colt’s record with this gun, I assumed the barrel nut was loose. Got my armorer’s wrench and it was cranked down to at least 35 ft. lbs. It didn’t budge.
I’ve cleaned out the BCG and firing pin channel. Looks like I’m getting about .06" of firing pin protrusion. What should I be expecting from this gun?
Any other places to troubleshoot? I’d rather not deal with shipping back to Connecticut for repairs since I’m in the middle of a move then out of the country for a bit. I’d just hate to wait until May to get it fixed.
The first place I would look is at the hammer spring. Does it appear to be installed in the lower properly? Maybe someone on the assembly line was having a bad day.
0.060" should be plenty of firing pin protrusion to ignite a pistol primer. Are the light primer strikes centered on the primer?
Check the chamber. Make sure there is no lube or anything else that would prevent the round from fully seating. What happens is that if the round is almost fully seated and the firing pin hits the primer, it pushes the round the rest of the way into the chamber before fully compressing the primer enough to go off.
Of course! Ran five boxes through my G43 without a single hiccup.
Ding ding ding! I think we have our winner!
Cleaned up the chamber on your advice and took the pony out to the range. Ran 150 rounds through it using some Blazer Brass 124 grain and the Remington UMC 115 grain.
Now that it’s up and running, it’s running smooth. No hiccups at all but damn, that’s a dirty shooting gun!
