New 870 Sights

I finally managed to get a new Remington 870 barrel with the “DEA Sights” on it. 18", Imp Cyl. The new sights look odd at first. The rear sight is mounted just forward of the receiver. It is low, very beefy, and blocky. It looks VERY sturdy. The blade is the express type with a white vertical center line. This is NOT the replacement XS sight for the Remington factory rifle sights. This is a sturdy fixed rear sight.

The front sight is a white dot on a ramp. I got to do some preliminary testing today.

Federal 00 Buck, 2 rds @10 yds, 2 rds @ 15 yds, and 1 rd at 25 yards, all on one target. You could cover the pattern from all five rounds with my hand with the fingers spread out. Centered right on the sights.

Winchester Ranger Low Recoil slugs, 5 rds at 25 yds, offhand, fairly quickly. 4 of 5 went in the same ragged hole, 5th was barely out, my fault. Dead on the sights.

Brennekke Tactical Home Defense slugs, 5 rds at 25 yds. Bigger group, centered but low. That barrel definitely prefers the Ranger slug.

The sights are very quick to pick up and look REALLY rugged. I like!

Pics?

Good pics can be seen here

http://www.gunbroker.com/Auction/ViewItem.aspx?Item=158760248

Is there a part number for this barrel in the 18" length??? I can only find it as 14-incher…

thanks

blake

Is there a way to mount a front tritium dot?

Sent from my SCH-I510 using Tapatalk

I certainly haven’t located 158760248. :confused:

Is this the barrel? http://www.gunbroker.com/Auction/ViewItem.aspx?Item=250026876 … If it is, how do you adjust the rear sight for windage & elevation?

Tom’s post was from 2010 :wink:

LOL! Sure got me. :stuck_out_tongue:

Contact J.D. at http://aiptactical.com/ . He can get you this barrel.

Thanks - I’m on it…

blake

The part number you need is F249630 870 12/18.5 IC RS XS barrel assembly.