Need Help! My AAC QD is completely locked up.

This has happened before and I was able to break it free. I cleaned it thoroughly the last time it occurred. Now it feels cemented on. I’ve tried heating it up from the outer surface - no luck. I used my regular cleaning solution, but that didn’t do anything. What’s the magic cure? Any help is greatly appreciated.

Thanks

adam

I used PB Blaster and a strap wrench on my AAC can but only after I tried getting it off by shooting it thinking that would knock it loose or get it hot enough to come off…

I sprayed PB blaster all around the mount into the can a few times and let it soak for a few hours then used the strap wrench while my wife held the gun tight until it eventually broke loose. Someone will probably come along with a better way but that worked well for me.

Also to get all the carbon build up off of the brake I used a drywall sanding sponge. I scrubbed the mount until it was all gone and cleaned the mount until it was squeaky clean and also cleaned out the threads inside the can very well. I lubed them both generously with fireclean and let it sit for about a week until my next range trip.

Now every time before I go to a class or the range to shoot I make sure there is a nice coating of fireclean on the mount and I haven’t had the problem since.

What can is it? Is the latch seized? Might help to know what the platform is and what can specifically.

It’s a mini on a 51T brake. Is there a solvent I can soak it in? That won’t affect the seal on the brake?

What seal are you using on the brake? Rocksett, Loctite, or something else?

Kroil - http://amzn.to/2e38dnm. That’s what AAC will tell you to do.

When you get it off you want to apply a very thin layer of Nickel Anti-Seize and this will not happen again - http://amzn.to/2dANTI5

Kroil is great for Rocksett, not for Loctite for this.

OP are we talking about breaking the seal on the locked can or on the break?

Is the latch seized?

kroil ordered with needle dropper. Not sure what was used on the brake. I had the brake and barrel installed.

The can is locked up. The latch button presses freely.

Turn the gun muzzle down and add the Kroil between the break and the can. Let it sit for about an hour and try to break it with a strap wrench.

Rubber mallet and tap it all around where the silencer meets up with the brake… go around it a good 2-3 revolutions.

Shoot a few rounds through it, then try while it’s warm.

Okay, so I plan to shoot a few mags to heat it up, drip some kroil around the 51T connections, beat it with a rubber mallet (2 -3 revolutions), then use a strap wrench to torque it off. ;).

I hope all this works and my can functions afterward. Next up, proper preventative maintenance from future recurrance.

Seriously, thanks for the help. I’ve got an M4200 inbound and my 10.5" is the targeted host. That’s the rifle the mini is stuck on. It’s got to come off.

Adam

When you get all squared away, wipe some Nickel Anti-Seize around the threads and the tapered base of the 51t mounts or if you want to can take a small paint brush and spread it around inside the threads of the can. You can then wipe it off and since I started doing this I have never had a can lock up on me again.

I’d be careful about beating anything with a rubber mallet.

How many round did you fire with this attached? 3000?

AAC 51T system are is one of the most generous clearanced mounts in the market.

Was kinda wondering that myself…I take my can off after every range session and at least wipe down the exterior of the mount.