Need advice on 223 powder measure

I’ve been using LEE PERFECT POWDER for powder dispensing with a LEE Single Stage for spartan 223 reloading. After using it for more than a year and more than 2,000 rounds – I have noticed significant wear on the innards of the plastic wheel.

I’m planning to upgrade and invest considerable more :frowning: to replace it. But I would like to still maintain a separate powder measure rather than press-based/cartridge-activated. I’m looking at either RCBS Uniflow or Redding BR3, although I’m confused on which accessories are needed. Please recommend which item(s) and accessories are needed. You can also recommend other brands or solutions.

My 223 loads uses either 55gr FMJ, 62gr FMJ, 69SMK and 77SMK, so I adjust the micrometer from time to time.

As a result of this wear, are thrown charges showing increased ESs/SDs? If not, I’d adjust my thought process and accept that the wear either isn’t as excessive as originally assessed or accept that it just doesn’t matter. If no changes in throw weights just keep using the Lee.

The rap against the PPM is it leaks some when throwing ball powder. You can tighten the drum/handle down to address this, but then the handle becomes more difficult to acctuate. But for extruded powders, it’s the cat’s meow. It has been tested on several occasions to be the equal, if not superior to measures costing much more. But it can be problematic when using fine grained ball powder.

If you want to upgrade to adress this, and are only using it for .223, then I’d go with Redding, they have a good reputation. Not sure if I’d go with a BR-30 or one of the larger measures that allows throwing larger charge weights. But the BR-30 will cover .223 charge weights.