I have a 16" BCM BFH 15" KMR upper, and when I got back from the range the other day I noticed what looks like rust building on the front corner where the gas block makes contact with the barrel, and also on the front set screw. This is not present on the rear of the gas block, only the front.
I’ve only shot this upper twice, about 200 rounds each time with only factory ammunition, cleaning it immediately after each session and relubing with Slip2000 EWL. I also punched a bore snake through the barrel each time, but never lubed the barrel or gas block (I was never told to lube the gas block).
I contacted BCM and they said what I’m seeing is probably something called “blow by” and not rust but that I was more than welcome to send it in and have them inspect it if I want. However if possible I would prefer not to send it in unless I have to.
I tried cleaning it with a q-tip and some CLP which didn’t remove anything, then I tried a q-tip and some Birtchwood Casey Gun Scrubber and it removed most of it. However my main concern is that if it is in fact rust, if it’s still underneath the gas block could it grow and rust through the barrel if I don’t remove the gas block and scrub all the rust off? (If it is rust). What do you guys think I should do? Here are some photos I took, I apologize but it was hard to get the camera to focus through the keymod.
Hard to tell by pictures but I very highly doubt it’s rust. Looks like lube to me. Good on BCM for offering an inspection.
Chances are if your 400 rounds are from a bench or other slow’ish shot cadence, you haven’t even got the barrel hot enough to burn off the factory lube yet.
Blow by is when gas sneaks out between the gas block and the barrel. It will push lube/leave deposits. Most blow by leaks self seal as a rifles round count increases.
After quickly ensuring the gas block was tight, I personally wouldn’t worry about it. Send it back and let them check it out if it concerns you though.
If it was rust, you would see concentrated spots and buildup.
If you’re still worried about it, dowse your barrel with Eezox (it’s made for rust prevention on firearms), just don’t get any on your polymer parts or paint. Eezox will hands down prevent any type of rusting whatsoever.
Those photos were taken after I tried to remove it with clp and a q-tips, but was dry before. The dark orange, brownish rust color is what concerned me. My only worry is that there is rust under the gas block and the gas pushed out the rust which caused this. But I don’t see how on earth rust could develop under the gas block considering I’ve only shot it twice (indoor range - no outdoor elements or anything) and immediately cleaned and lubed after with EWL. BCM (as always) is fantastic and has superb customer service which is why I don’t want to send it to them unless I’m sure this is serious and there is rust under the gas block that could be eating away at the barrel where I can’t get to it.
I don’t see rust either… Look at it this way, if you did have a little rust under there, your not likely to live long enough to see it be a problem😀 Enjoy your quality rifle op!