I’ve used the Magpul wrench several times to install standard flash hiders. Today I went to install a Surefire SOCOM 7.62 SF3P flash hider and found that the wrench flats are exactly .750" where as on the typical flash hider wrench flats (I had a few lying around) were always .003" to .005" under .750".
My Craftsman 3/4" open end wrench is too thick to fit the wrench flats. I used to use an old, off brand, ground down wrench but I thought the Magpul would accommodate the Surefire.
I’m picking up a Brownell’s AR15 wrench (shown in a Surefire video working with their products). Boils down to standards vs. other standards… :rolleyes:
It took me a while to move over to the Magpul wrench and now that I have, I feel like an idiot for not moving over to it sooner. Hands down the best armorer’s wrench I’ve ever used.
For flash hiders I have an old S&K wrench that works perfectly.
The Magpul wrench is the best of the “combination” or “multi” type wrenches… The more purpose built task specific wrenches still do a better job though.
My favorite barrel wrenches are made by 2UniqueLLC and BRD Engineering. My favorite stock wrench is made by Brownells.
I like my Magpul wrench for what it is. In addition to what’s mentioned, another limitation is the enclosed castle nut wrench doesn’t fit over some pistol buffer tubes.