low pro gas block

I have a LMT upper with troy drop in battle rail, it has the standard front sight. I just got a Eotech 512 and would like to run a low pro gas block and flip up sights. Is there a low pro gas block i can use and keep the 2pc drop in rails I already have?

this is the best pic I have lol its the rifle on the far right.

You should be able to install a lo pro gas block and keep the handguard cap in place for your drop-in rail. It’s kind of a weird way to do it though. If you’re keeping the 7" rail you might as well have the benefit of the fixed FSB. With the Eotech mounted for 1/3 cowitness you won’t even notice the front sight when shooting.

The front sight bothers me when using the Eotech, thats why I was considering it. Just didnt know if it was even possible.
Id rather free float, just a little short on cash from Xmas and Bravo company orders lol

The 512 is an absolute co-witness. How many rounds have you had through it in that config?

Is your EOTech on a riser mount?
If not, THESEusually help.

This is the best way to go because you keep the standard FSB and you can still maintain co-witness.

If you still feel the need to change the FSB, YHM makes good flip-up front sight gas blocks. I don’t know how the rest of these guys feel about YHM; I have had good luck with their flip-up front sights and muzzle devices. I’m sure there’s better quality flip-up FSBs on the market.

With that said; I would use the riser mount suggested by Dave L. because you are not changing the configuration of your rifle.

haven’t shot it with the eotech yet. I like the riser suggestion and would have done that but I sold my Troy rails and panels to a friend this after noon. Im going to get free float rifle rails and a low profile gas block with flip up sights.

In that case, just shave down your fsb. It’s the cheaper and most solid option.

If you go this route, get a 9" rail and cover the gas block while your at it.

This is the way to go for sure. I am doing the same thing asap, only I will likely go with a 12" TRX.

To answer your original, I don’t know about the quality but the PRI flip up front/gas block would have worked. Not a cost savings over what is basically a better system with a longer rail and shaved FSB.