In a new factory-assembled LMT lower, the M4 stock requires some considerable force to move and it does not collapse fully (about 1/4").
Anyone else experiencing this with new LMTs?
Thanks. ![]()
In a new factory-assembled LMT lower, the M4 stock requires some considerable force to move and it does not collapse fully (about 1/4").
Anyone else experiencing this with new LMTs?
Thanks. ![]()
My LMT SOPMOD stock is definitely stiff/tight, but not impossible to move.
They build the sopmod stocks tight on purpose. This way you have a constant.
My Sopmod stocks are tight, in that they don’t wiggle, but they are easy to adjust.
All the ones I’ve handled have been tight (which I like) so this isn’t a reason for concern. Additionally I wouldn’t worry about a 0.25" gap between the plastic and castle nut.
I just picked up a new LMT lower with a Sopmod as well. Dated 12-08-08 I think. Anyway, it is very tight but I like it that way. I am sure over time it will loosen up. What really suprised me about the lower was it’s super tight fit to my MRP upper. I had to really push down on the upper to get the pin through. This is an older MRP that had been mated with a LMT lower, which was much loser. After getting the new lower for a different project I switched it out because of the tightness. The MRP has a stainless barrel and is scoped so I thought the tighter lower with the tight Sopmod would be better suited on the MRP. I am just hoping everything is in spec. Anyone else notice this about the lowers. My new one is 39XXX and my old one is 31XXX.
My LMT Defender stock is tight also…and has the aformentioned .25 gap.
Thank you, all, for your input. I was referring to the M4 stock, not SOPMOD.
Any ideas why it is so tight? Do they use a bigger extension or a tighter stock?
On the tag that is tied to the receiver, the stock movement checkbox is checked and the tag is signed by the QC, so I guess they do intend them to be tight.
Mine’s the exact same way, tight and has a gap…
That’s weird. My M4 stock that came with my LMT Lower was smooth and not tight at all. I installed the SOPMOD and it is a little too tight. The SOPMOD worked better on the VLTOR tube.
Another problem I had was the lower meshing with the upper (MRP). Too tight and very hard to get the back pin in and out. Sent the upper back to LMT so they could grind the small tabs off of the front near the front pin. Works like a champ now.