LMT BUIS

Does the LMT BUIS return to zero when you remove and put it back?

I’ve never detected a loss of zero. I’ve only taken it off once though.

In my experience if you remove an Eotech, ACOG, etc…or a BUIS and put it back in the same rail address you will have minimal change. I did it frequently with my ACOG that was mounted in a GG&G Accucam and I never had issues hitting my target afterwards.

If we are talking a precision weapon and optic that’s a whole different story.

I asked coz if I can get an ACOG. I will have to remove my LMT BUIS. and when I put it back on again… I don’t want to spend an hour or 2 zeroing again.

what is up with the Nike post???

Dunno but he has a similar post in the AR General Discussion/Only 1 Gun; What Do You Choose? thread.

TROLL ALERT!!!

Mods, would you please check this out?

nobody quote him… less work for the mods.

so anybody else? so… it would be safe to remove the LMT BUIS and not loose zero assuming I put it back to it’s original slot.

the LMTs are nice 'cause they’ve got that locking 1913 block on the bottom that pretty much locks it back into place. you’re going to lose SOME degree of zero, but probably not enough to even notice. i’ve removed and reinstalled them without re-zeroing before, without issue.

eta: just make sure your knobs dont get fucked up while it’s kicking around in your pack or pocket or however you stow it.

Im not putting it in my pocket or something. I might decide to go to the range with a scope so i’ll configure it in advance before leaving home.

yes I noticed the locking lugs of the LMT BUIS. so it’ll never move forward or backward. my concern is shooting left or right. as we know LMT BUIS mechanism is just a screw. how tight I install it will affect zero. if it were a QD like Larue (wish I bought that) it wouldnt have to worry.

I will also have problems with my scope since they are just weaver mounts. and not really for picatinny. still screw on lock.

Just make a little mark next to the screw base to let you reset to that tension upon reassembly, ensure you lock down or dont move the sight when its off (adjustment dials) and when you put it back on you will be fine… remember you are talking iron sights here… you will not notice a change in zero… not like on a high power scope. I have done this on my LMT and its not noticable at all even at 25m. same 3/4 inch hole all the time.

Patrick

alryt! so i’ll use a blue pen right

Whatever shows a shiney reflective spot … I use black sharpie marker… doesnt rub off(unless you rub hard with CLP) and I mark on both the thumb screw barrel and the bracket . I seat the rear sight with forward pressure when applying the twists to the thumb screw as this is the direction in the 1913 rail the sight would drift if loose due to recoil. so push down and forward and go for it. remember also you dont need to reef on the thumb screws.:slight_smile: as long as you keep the reattach procedure consistant time and again you should be set.

ok thanks for the input will try that this weekend.