Hi all,
I have the T1/LT660 Tall mount on my carbine. I was finally going to pull the trigger and get the 3x Magnifier/LT649 QD swivel combo, but it looks like its been replaced with a new mount (LT755). the website states that the new mount placed the magnifier at 1.725" centerline. however, I can’t seem to find measurements on my T1 combo. Does anyone happen to know if the two would be aligned? thanks!
Hi folks,
I contacted the folks at LaRue and they got back to me after a few days. Here is the response:
“The LT755-30T does work with the T1 on the LT660. There is a slight offset in centerline height, 1.7” for the magnifier and 1.64” for the T-1. The magnifier has an adjustable prism, so you can center the T-1 dot in the magnifier by adjusting the top and side set screws.”
So it sounds like the same setup as the older LT649 swivel mount. Hopefully this helps someone else out in the future.