(I searched and couldn’t find an answer to this question)
I just got mine today and noticed the buffer has “SR-15” lasered on it. My main question is, is this a standard buffer or is it something different?
if it’s standard, why would KAC go to the trouble of engraving “SR-15” on a regular buffer?
if it’s non-standard, what is it? i’d like to know in case i need to replace. (assume just because a rifle CAN go 20k rnds w/o replacing wear parts doesn’t mean you SHOULD go 20k rnds w/o replacing wear parts…) i looked on their website and couldn’t find a buffer listed, but i may have missed it
I’m curious because the rifle has KAC’s ‘midlength’ gas, and for whatever reason they chose to use the lighter carrier (that won’t trip the auto sear, not that they need it on this rifle, of course). Also, i figure it’s not outside the realm of possibility for KAC to make a special buffer, since the buffer in my SR25 is solid nylon or delrin or whatever you call it.
did they do a ton of research to determine the optimal mix of those components for this rifle? (and hence, i shouldn’t screw with it)
or were these parts just chosen for mfg convenience and it would still run fine if 7k rnds from now, i replaced it with either a standard or H buffer?
I have had an E3 since last Fall & have another on order that is due in to my FFL any day now. My understanding is that the buffer, gas system length & barrel / gas port size were all designed as a proprietary system designed to give good reliability and extended lifespan of the parts. Of course the bolt was redesigned with similar parameters as well.
I think that the E3 “SR-15” buffer is a different weight than the standard carbine buffer. Swapping out the buffer or spring will probably have negative results for reliability.
Remember that the gas tube is nearly as long as a rifle-length. It’s not your traditional mid-length at 9, or even the intermediate at 10; it’s really closer to 11.