deleted
deleted
deleted
is there a spacer on the inside of the KAK tube, since it’s longer than a standard carbine tube?
I can’t believe the timing…I just ordered a KAK Supertube this morning to do the very same thing! Only difference is I’m not going to use a spacer, just go for the extra ~ 1" the Supertube gives me over the current Thordsen buffer tube (I bought the whole kit a while back).
Thanks!
Question: Which of the screws will I have to remove to get the CAA saddle/Thordsen tube off? The four at the front, the two at the rear, or both?
Yes, I believe there is.
deleted
deleted
Why are you talking LOP with a pistol? Just use the damn thing as intended - as a better cheekrest.
I want to take the whole kit and kaboodle off and put it on the KAK for an improved LOCW (length of cheek weld). I know the front 4 (2 on each side) have to come off to get past the non-functional protrusion that usually has holes in it. I was just wondering if the rear ones had to be removed or loosened also. It’s just that it was such a PIA to assemble (the “instructions” sucked) that I didn’t want to take it completely apart if I didn’t have to.
deleted
LOP can still apply to an AR pistol - some people like to hold it out further or closer in - without it touching the shoulder. not everyone shoots an AR pistol NTCH, so the position of the cheek may change.
I have to disagree - LOP only refers to the distance between the trigger and buttplate. If you need a longer distance from trigger to cheekpiece, it’s not LOP. I shoot both of my pistols with cheek weld only, and not NTCH - I can’t see how a longer position on the CAA saddle will help there. Again, LOP implies shouldering.
My only issue with this set-up is I haven’t seen any ATF letter of approval. I’ve seen the letters on the website. One saying the cover is not a stock and the one for the sidesaddle placed on a buffer tube (which specifically stated it only applied to that exact set-up- last couple of sentences).
http://siterepository.s3.amazonaws.com/2675/ar_pistol_letter.pdf
I would love to see an ATF letter approving as exactly set-up as you or Thordsens website has it.
If anyone has one or link I’d appreciate a post here.
No more letters please
deleted
well, we can call it something else then, that describes what it is. what would you call it?
My only concern is the set-up you currently have is not what Thordsen submitted and had approved by the ATF. Hence the two different letters they post.
OAL would work.
[content removed]