Gas ring question

Guys,

Is it easy to mangle or otherwise ruin gas rings during an install?

Are there any “how to” helpful tips/hints out there? I’ve read a lot about it, but what I’ve read doesn’t make sense to me. My guess is that it’s something you need to see…not read.

Its easy to do…getting the old ones off just use a tool of suitable nature to get em off. The new ones I just slide up the back of the bolt tale, and then use a tool to snap one side of the ring into the recess on the bolt. Once one side is in just push the other side in. Repeat 2X more and thats that. Never mangled one or had any other issue.

It’s easy. It kind of reminds me of putting a key on a key ring. Start on one end and go in a circle.

Thanks guys.

Any experiences with one of those MacFarland one piece jobs?

Haven’t bought one yet.

I use them on all of my AR’s and used them on our Bushies in Iraq (approx. 200 were outfitted). They worked for me.

I use them on my duty rifle and on 3 other friend’s rifles whom I set up.

They show no visible wear after a total 1900 rds through my current BCG. I get my McFarland rings from G&R tactical, as Brownells sent me two pairs of under-sized rings…I think they got a bad batch.

It’s a bitch getting them on from the front of the bolt! :stuck_out_tongue:

I can’t wait to read that question on ARFcom…