GAP 10 continuing issues with pressure

While accurate/precise and reliable in function after a trip back to George’s shop this individual rifle continues to be unable to digest factory ammunition (FGMM - 168 grain) without piercing primers. Thus it is eating firing pins faster than guys gulping hotdogs at a Coney Island contest.

Caliber .308, barrel length 20".

FWIW; reloaded rounds require minimum charges and velocities chronograph at 2400 ft/secs with 175 SMK’s at peak attainable safe observed apparent pressures. Roughly this translates to a powder charge which is 15% under what a comparable bolt action would digest.

So if anyone has had a similar experience and found a remedy I would love to here some feedback.

Pierced primers result from a combination of:
Pressure
Primer cup strength (thickness and hardness)
Fit/Clearance between firing pin tip and hole in bolt
Early action unlocking (overgassing or light buffer or short gas system)

My lunch money is on the bolt+overgassing.

I don’t know a whole lot about reloading, but I thought it was just a known fact that you have to back off on the powder for semi-autos. My friend reloaded some rounds for me that were minimal for bolt gun specs and yet we blew the brass apart in my Larue tOBR. The loads he made that are safe are also minimal and we still get flattened primers every now and then. We’ve had to play with the crimp a lot to prevent set back but yet prevent too much pressure (forgive my verbiage if its off, I’m not the mad scientist, just the trigger puller). We’re still spinning our wheels to come up with a good load for it tho.

Fortunately I can still shoot 168 FGMM safely and get ~2495 fps out of my 16" barrel. I’d lose my mind if I couldn’t shoot factory ammo with it.

What does GAP say about it?