My nephew’s issue rifle is a 10.5 BCM upper on a Colt select fire lower. Semi auto seems ok with all ammo tried. On full auto it works better with .223 ammo than 5.56 but still not 100%. You can really hear the cycle rate go up with 5.56, it almost sounds like a MG42. It has what appears to be a standard carbine buffer. My guess is it needs a heavier buffer. What do you guys recommend?
Maybe I’m misunderstanding, but if it’s his issued rifle, then I’d leave it the heck alone and let his armorer worry about it.
BCM doesn’t make a 10.5 URG. Is it an 11.5 cut-down?
At a minimum, use an H or H2 buffer.
Yeah, your right. It may very well be an 11.5, he thought it was a 10.5. I was thinking either a H2 or H3, may start with the H2 and see how it runs.
They don’t train with the fun switch so I’m not sure the armorer is fully aware of this issue. This is also a new item for the local armorers so they may not have much experience with it.
How is it malfunctioning?
My guess is the cycle rate is so high the hammer is following the BCG home. It stops cycling, dead triger, with a round in the chamber. It seems to have a high cycle rate which goes noticably higher with 5.56 ammo.
A. Define the malfunction.
B. An H2 would be the recommended in this case.
C. The department armorer should be dealing with this. Full Auto or not.
That is typical bolt bounce. H2 is recommended and it would most likely run fine with an H3.
Well, if there is no marking on the buffer, it’s a carbine buffer. You should use the heaviest buffer that will lock the bolt on your weakest ammunition. That probably the easiest place to start otherwise you need to see what size the gas port is and determine if an adjustable gas block is the way to go.
Thanks guys, I’ll see if I can find a H2 and maybe even a H3 locally, if not I’ll order one.
This makes me think you may want to check the FCG for proper operation. The higher ROF may be caused by improper sear engagement resulting in hammer follow as you have guessed. Bolt bounce does not increase ROF, it just shuts the gun down.
Playing devils advocate, if it’s over gassed, it will cycle fast, and if it has a light buffer, it would seem that would lead to excessive bolt bounce which would cause the malfunction. This would also be more likey than an improperly assembled lower if it’s factory.
Either way, it is 10 seconds to check for proper sear engagement before throwing parts at it. I am more inclined to think it is worn out than improperly assembled.
eta
also you can verify bolt bounce with a iPhone @240 fps.
Skyyr and Iraqgunz are right.
If:
A- It’s a department owned full auto,
B- Full auto isn’t part of their regular training, and
C- Semi-auto is functioning fine
Then…
Leave it alone.
It’s the department’s gun (not his or yours), and the armorers or the factory should be the ones to deal with it. Have your nephew report the concern to them and see what they want to do with it. If as you say, they might not be aware of it, then your nephew speaking up might not only solve his problem, but he might also help uncover issues with other officers’ guns.
Is he allowed to swap parts on a department issued weapon? I’d let the department armorer deal with it. If anything ever goes wrong - even if it has nothing to do with any changes your nephew made to the weapon, he could be hung out to dry.
Bolt bounce, I’m almost certain of it. Heavier buffer should rectify it. Let the armorer do it though
what you are describing is Remote Control Attorney Viagra. diddledorking with a department issue weapon will give every lawyer in a 250 mile radius wood. you are accumulating the perfect storm of liability for yourself, the department, and the political overseers of the department.