Fail Zero gas key and carrier?

Does anyone know if the Fail Zero bolt carrier and gas key are hard chromed in the bores? If they are nickel boron coated without the hard chrome underneath is the Ni Boron going to wear as well as hard chrome?

These areas are subject to erosion by hot gas so it is not just a friction issue.

Fail-Zero forum: https://www.m4carbine.net/forumdisplay.php?f=107

Questions about Fail-Zero thread: https://www.m4carbine.net/showthread.php?t=35550

Asking in there will probably get you an accurate answer fastest.

Nickel-boron is as good if not better than hard chrome. I had been considering a Failzero bolt assembly, but wasn’t sure about the heritage of the underlying steel parts. Went with a melonited BCM group instead.