DYI relieved ambi selector

I’ve had my RRA ambi selector over 2 years now. I liked this particular design because the set screw is inside the receiver (on the bar itself) and not outside. There’s pro’s and con’s to the design, but after prolific use (and sample size of one), it’s still solid and works well.

After seeing the BADASS and KAC’s relieved/beveled selectors, I decided to do something similar myself. All I used was a Dremel with the standard and thin sanding drum. I also had some jeweler files to clean up the edges. After grounding in the relief, I polished the surface, blued it, then hit it with Rustoleum paint.
It didn’t take that long, about 20-min of work total.

Standard dimension:

Relieved dimension:

Concluding thoughts: I could have relieved it more to make it thinner, but the base of my index finger already cleared it (no longer rubbing). I also wanted to retain enough thickness so I could still use my index finger to actuate the selector back on safe.

Do I feel this made a big improvement on selector manipulation? Honestly, not really. Probably not really worth the work, but it was pretty easy to do. Is it a little lower profiled to where it doesn’t rub on my index finger as much? Subjectively yes.

After doing this modification, I don’t know if it’s worth paying extra for the ambi-selectors that have the relieved tab on them…but options are always a good thing.

Nice job. For the most part it looks clean.

Nice work. Looks like it was made that way

Thanks guys.

Great job. If you don’t say anything, I’d doubt anyone would be able to tell it wasen’t purchased like that.