Has anyone got a Lopro gasblock, like this under a rifle length Omega rail?
I want, but the website says it’s not meant to happen. Has anyone tried it?
TIA,
Kent
Your best best is DDs pinned low pro gb and even that will be close i think. There’s not a lot of room in there to clear the bottom part of the block you linked.
I had the fsp cut to fit and it required a lot of sanding and grinding to fit under my omega. Go with the DD just to be sure or you will find yourself behind the grinding wheel
I have the cmmg micro gas block running inside the 12" omega rail on my 16"midlength. Zero problems so far and have run hundreds of rnds.
Sent from my Galaxy Nexus using Tapatalk 2
How much clearance do you have between the bottom rail and the underside of that block? I looked it up and it looks really slimer than most.
I will try and take a pic or dig up an old pic to post for u tomorrow. Its tighter around the upper portion of the gas block where it contours up due to the gas tube iirc.
Sent from my Galaxy Nexus using Tapatalk 2
I used that exact Low Pro gas block under a Daniel Defense Omega X and it fit just fine with no clearance issues. You are good to go.
Recommend the CMMG micro as well. Not many LP GB’s will work, I remember my buddy trying to fit a larue, YHM, and another brand under the Omega, all of which wouldn’t work. The YHM could fit, but would need some mods.
I think their MK12 GB is designed for the rail or it will at the very least it will fit with no issues.