I outfitted my middy build with Calvary Arms furniture. Everything is good except that flimsy rubber buttpad. I had to put a one inch washer on the top screw to prevent it from pulling right through the rubber pad. The butt compartment door is different to say the least! Where can I get a hard buttplate to fit that buttstock? Thanks for any suggestions.
Go here: http://www.fulton-armory.com/
Under the Ar15 lower receiver parts they list an A1 butt plate and door assembly. I have a couple of them. They are well made and fit well. You will also need the top and bottom screws and a mil spec sling loop to replace the crap Cavalry supplies.
Thanks DBR! That is exactly what I am looking for.
+1 to DBR. The buttplate that FULTON ships with their C1 stocks is very nice. It matches the stock almost perfectly. You’ll be pleased.
Is the stock of good quality other than the buttplate? I’ve thought of trying one instead of the surplus A1 stocks I normally use.
I love it! I haven’t tried beating the shit out of it to see if it can take it. But it feels like a solid unit… not brittle.
Order the complete stock for $49 at Fulton. I don’t think you’ll be disappointed.
Funny. Just returned a Calvary Arms buttstock to Brownells. Not only did the rubber buttplate suck, but the retaining screw was coarse thread.
Could any of you that use the Fulton Armory A1 buttstock post some detailed photos of it? Especially the inside of the stock under the trap door? I have been searching for years for a quality A1 buttstock. I would like the same quality that I have on my Colt A2 stocks. The Colt A2 stocks are very well made but a tad too long for me.
The Calvary buttstock is okay, it has some mold lines on it. The one inch steel washer on the top screw keeps it tight but I put some good money into this build, BCM middy upper, BCM BCG, Spikes lower ect…, and I feel the butt looks like shit. Fulton wants $39 for the parts to make it right plus 10 bucks shipping.
I think that I will live with it for now and save for a Magpull stock.
So far as I can tell the Fulton stock IS a Cavalry Arms stock. Fulton just supplies a much better butt plate, door and hardware.
The stock is glass filled nylon so I think it is pretty strong. The inside compartment is not foam molded, it is just part of the molding and is a bit larger than the A2.
The only problem I have had is the front end of the stock can require a bit of fitting if you want an absolutely even fit to the receiver. On the four I have used there is a slight gap on the right side where the stock meets the receiver.
Cavalry re-did their tooling a year or so ago and the overall stock is better finished than the older ones but the front fit is not quite as good.
Edited to add: The mold lines are easily scraped off and I bead blasted mine to get a nice flat dark gray finish. They can also be painted.
I might be able to tonight…