Posted here by request:
////
Yesterday afternoon, I did an initial acceptance inspection of Bushmaster “Patrolmen’s Carbine” for a LE agency adding this carbine to it’s list of authorized units.

Control samples were used in the eval, a Colt LE6920 and AR6520, DOD Colt M-4, FN M-16A2. All are currently issued/authorized.
Highlights:
-Circumferentially larger and longer (3/4") receiver extenion, curiously so. End of stock cut at an angle. Buttstock of questionable material quality and durability.
-Castle nut is not staked.



-Standard rifle carbine extension and receiver. (No M4-type feedway cuts.) (Indifferent, if functional)

-Shrouded bolt carrier with SA rear tang. Bonus!
-Supplied with rifle extractor spring with blue insert.
-Properly staked bolt carrier key.

-30rd magazine was supplied with green follower of soft and easily damaged plastic material. A similar mag like this melted in an auto gun in another unrelated eval. Distinctly different from milspec magazines.

-Charging handle of thinner material than control samples. Bending is a concern if the handle receives lateral pressure.
-Pistol grip contains hex-head screw.
-Handguard of lightweight plastic, small prongs holding a single heat shield, prongs will likely melt.
-FSB appears TDC and uncanted.
Carbine has conditional approval by the agency pending demonstration of live-fire function and durability of components questioned, change of the grip screw, extractor spring, and staking of the castle nut. Magazine discarded.
////