Berry's Bullets?

Are these any good?

I’m looking for plain-jane M1 Carbine bullets, and Berry’s are $94/1,000, shipped.

I can’t find bullets any cheaper, anywhere.

Please advise,

Bimmer

I use them for 9 and 45. They do the trick. I’ve loaded thousands of them.

They might be a twat hair less accurate than regular jacketed ammo, but the price diff is well worth it.

I have tried them in 9mm .45 and .44. The .45’s shot very nice. The 9’s were horrible but I haven’t found a plated bullet yet that shot worth a damn in my Glock. In the .44 they shot like crap at first until I backed off on the crimp.

I’ve had decent performance in my 9mm glock. I’m using the 124 grain flat nose plated bullets on top of 4.3 grains of WW231.

I haven’t been impressed with them, accuracy wise. Does Montana Gold make a bullet for the application you’d be using them for? I like those much better.

I’ve since heard from elsewhere on the errornet that “plated” bullets are a bad idea for rifle rounds, and that I should stick with “jacketed” bullets for .30 carbine.

I’m not too concerned about accuracy out of my ratty old M1 Carbine, but I don’t want to deal with a lot of copper in the barrel or bullets coming apart, either.

I’m still thinking about this, though…

Bimmer

It depends on how fast you are pushing them. Most plated manufacturers say to stay below 1200fps, but I’ve pushed some Berry’s faster than that and they didn’t come apart or do anything weird.

Jacketed will still probably behave better for you though.

This is the problem… .30 Carbine is typically 2,000fps or more.

I don’t doubt that these are fine for pistols (I use cast lead in my Glocks), but I’m hesitant to use them for .30 Carbine.

Well Berry’s says not to push their .30 Carbine bullets any faster than 1600:

http://www.berrysmfg.com/338.php

I shot some of both a few weeks back. I didn’t print any on paper, but both were capable of hitting the 10 inch plate at 30 yards out of my G17.

I posted this elsewhere, but I researched some bulk bullets fairly extensively:

I have been using Berry’s plated pistol bullets for quite some time, but of late I have been less than impressed with them, accuracy wise. So I set out to find something better, if I could. I had heard good things about both Precision Delta and Montana Gold, so I ordered 1000 each from those guys. I then set out to measure and see what I could find out. I included Berry’s into my comparison so that it would give me some idea about how much variance there was between my old standby and the new things I was trying out.

I am only interested in 9mm 147gr round nose style bullets. Please understand that these measurements and my observations are a moment in time, and cannot be considered indicative of these manufacturer’s other bullet weights and calibers. Also you should know that the two batches of bullets from Montana Gold and Precision Delta were recent, whereas the Berry’s I tested were from a year ago when I ordered in bulk. Today’s Berry’s may be better or worse.

With all of those caveats in place, I will state that by the time I was done with these tests, I know which bullet I will be using from here on out. But follow along…

I weighed and measured a sample of 30 bullets from each of those manufacturers. (30 being a significant statistical sample.) I weighed each on a Dillon scale and measured them in length and width with my calipers. I measured them to the best of my ability and to the best my measuring equipment could tell.

Berry’s Plated:

Mean Weight: 147.2566667
SD: 0.251455533
Min: 146.6
Max: 147.9

Mean Length: 0.671933333
SD: 0.000925997
Min: 0.67
Max: 0.6735

Mean Width: 0.356433333
SD: 0.000314405
Min: 0.356
Max: 0.357

Precision Delta:

Mean Weight: 147.3966667
SD: 0.179046003
Min: 147
Max: 147.8

Mean Length: 0.675866667
SD: 0.002785224
Min: 0.671
Max: 0.6815

Mean Width: 0.355466667
SD: 0.000182574
Min: 0.355
Max: 0.356

Montana Gold:

Mean Weight: 146.8533333
SD: 0.113664155
Min: 146.6
Max: 147

Mean Length: 0.634833333
SD: 0.000422091
Min: 0.634
Max: 0.6355

Mean Width: 0.355566667
SD: 0.000172873
Min: 0.3555
Max: 0.356

The things that stood out to me are as follows. Firstly, the Montana Gold bullets are beautiful. If it were a contest of looks, they’d win, hands down. The Berry’s look nice as well. The Precision Deltas look fairly dern ugly. If you look at the stats, the Montana Golds are freakishly consistent. Look at the really low Standard Deviation numbers. Those bullets are consistent in every dimension that I bothered to measure, much moreso than anything else I’ve seen at or around this price point. The Precision Deltas held bore/width very tightly but they were all over the map in length. That length variance played hell with me reloading them. I had to shoot for a very broad range of overall length for my loaded cartridges. And lastly, the Berry’s. They are much fatter than the other bullets, averaging higher than their stated 0.356".

One side note, both Precision Delta and Berry’s are slightly heavy. Both average out just north of 147 grains, whereas the Montana Golds average out slightly light. The only case where this is important would be trying to make power factor in IDPA or USPSA. If you are running the bottom of the floor and your bullets are just below 147 grains, you may very well not make power factor. That is a total bummer if you’ve ever been there, so adjust your velocity accordingly.

Of course, all of these numbers are nice, but the real question: how the hell do they shoot? I have to confess I was not having the best day on the trigger today. I was a little shaky and my eyes weren’t where they should’ve been, but you get what you get. At least I shot all of these back-to-back, so you get a pretty good comparison of what I was capable of with each run.

All bullets were loaded with 3.3gr of Titegroup, a Federal small pistol primer, and mixed cases. They were all loaded to approximately 1.130". The only variable was the bullet. They were shot at 25 yards, rested on my shooting bag. These were 10 shot groups, which I feel are much more indicative of real shooting, rather than a 3 or 5 shot group.

Speer Lawman 147gr (for comparison): 3.250", with much vertical stringing. I attribute that to me, this ammo is capable of shooting tighter.
Berry’s Plated: 5.870", although if you throw out one flier, it comes in to 4.336".
Precision Delta: 5.773", and this group was evenly distributed, I can’t find a flier.
Montana Gold: 4.784", and discarding the flier brings it in to 3.814".

Bottom line, the MGs shoot as one would expect, based on the lack of variance in the bullets. Unfortunately they aren’t the low cost leader, coming in a good $30/1000 higher than their competitors. Based on what I have seen here, I’ll continue to buy them. They shipped fast when I ordered, and I had no issues with them whatsoever.

If price is no object, I’d point you toward the Hornady XTPs. I’ve shot some amazingly tight groups with those, and all the ones that I’ve measured were a boring 0.3550. They’re also 0.18-0.20 a bullet, and that is why I don’t shoot them much, at least compared to some cheaper FMJ fodder.

I also think that Titegroup may not be THE best choice for accuracy behind a 147gr fmj, but it does pretty well, recoil is easy, muzzle flash is nonexistent, and the price is right. I’m probably going to stay with Titegroup, even though I just killed the last of my 8# jug on this test.

Anyway, there you have it, more than you ever wanted to know about 9mm 147gr bulk bullets…

The cosmetics of the montana gold bullet are what scare me. I get flashbacks to those Brass jacketed bullets from WIN a while back…

The ones you used to get a wally world. When fired in glocks, those were the most inaccurate bullets I’ve ever fired out of any real caliber pistol ever. I can remember guys seeing new packaging after that ammo came out. The new box said “improved accuracy bullet” or something along those lines. Apparently the accuracy problem was so bad that Win had to label subsequent ammo production accordingly. (imagine stocking up on that damned ammo)

I did fire a handful of the montanas thru my pistol with very acceptable results. Like I said… nothing on paper for a good comparison though.