barrel nut ?

I installed a barrel yesterday but when I put the barrel nut I was not able to align the nut with the hole in the receiver;

using just a DPMS wrench and my hands I got very close to the correct position but it was not enough…I decided to unscrew the nut a little and use the teeth before the one I could not align.

am I good to go anyway? or should I try to tighten the nut more?
the barrel has no movement that I can feel.

TIA

Frens,

Did you put the nut on and attempt to tighten the first time or did you work the threads? I would put the nut on and tighten it (1) more time to work the threads and then on the next attempt tighten it down for real. Remember there is also a torque value from 30-80 ft./lbs. Also, make sure that you use molybdenum grease or a similar type anti-seize on the threads.

In some situations I have had to try a couple of barrel nuts to get the hole to line up correctly.

I did work the thread but forgot the grease to be honest… damn! :eek: :frowning:

everything is fine now.
I’ve put the grease, tightened the nut one time and on the 2nd attempt I was able to align everything.

thank You sir

Dude, sweet.