I have read some info, and watched some videos. Just want to make sure I ordered the correct forms from the ATF.
Also the bottom two are both finger print cards. What set do I need? There was three options, one was for explosives I believe. The other two I was not quite sure so I ordered both. This is a direct copy/paste from my order.
ITEM_1: F 1 (5320.1) - Application to Make and Register a Firearm
ITEM_1_QUANTITY: 4
ITEM_2: F 5330.20 - Certificate of Compliance With 18 U.S.C. 922(g)(5)(B)
ITEM_2_QUANTITY: 4
ITEM_3: FBI FD-258LE - NFA, Imports ORI WVATF0800
ITEM_3_QUANTITY: 4
ITEM_4: FBI FD-258FA - FFL Application ORI WVATF1100 (Limit 2 Copies Per Order)
ITEM_4_QUANTITY: 2
Beyond these forms. I know I need two passport photos, a check for their nachos and beer for the month, and I believe I need to have my lower engraved. Anything else I am missing? I’m doing this as a individual if that matters.
You’ll actually have to use two of the Form 1’s (5320.1) per SBR. The correct finger print card is the 258LE. Ask if you have any questions about how things should be filled out. You don’t want to wait a almost a year to find out that you made an error.
Thank you
Yea I saw on a youtube video I would need 2 of each form. So where applicable I had them send me 4. Figured I’d make a mistake somewhere along the lines. Also kinda figured I’m sort of paying for the ink and paper anyways, so it cant hurt.
Also I understand I need my lower engraved? Where specifically is acceptable? I assume it needs to be on the left or right side, but is the front of the mag well acceptable? Or perhaps the inside of the trigger guard? I know this info is somewhere around the NFA section but figured I’d ask anyways
I engraved the SBR AR15 that I built in front of the mag well. Others do this as well. It’s a good location because you don’t really notice it, but it meets the requirements. Make sure that whoever you have engrave has plenty of experience engraving firearms. You’ll want a machine engraving, not a freehand engraving.