LRB Lower Receiver
Stag Lower parts kit
ERGO Grip
Magpul CRT stock
VLTOR Monolithic upper receiver
Daniel Defense hammer forged mid-length S2W 16inch barrel
AAC blackout FH
Young MFG NM FA BCG
Troy BUS
Troy rail covers
Eotech EXPS 3-0
Magpul BAD
BAD-ASS ambi safety selector. (I didn’t name it)
Nice looking carbine. Good set up.
looks good
Why did you build it?
Why did you choose the parts that you did?
Good questions.
Answers.
The build started when I had several stripped lowers laying around. When DD came out with the S2W barrel I wanted to try one so I picked one up. Along with other parts I had laying around Rainer sent out a email with the Vltor monolitich upper on sale. Always wanting to build with a Vltor upper and now having the chance to use the monolithic I picked on up.
As it turns out, no regrets. I’m not sure this weapon won’t out shoot my SPR’s.
I mounted a 3x10 Mark IV for the load testing. The thing loves 77gr SMK’s with 21.1 gr RL 15.
The Eotech was robbed off another carbine and with the PVS 14 makes a great combo.
Bottom line I guess is, I really didn’t per say choose the parts for this build. It just happened.
Very nice setup. How do you like the eotech so far?
I like it. Eotech’s just seem to fit me well.
Looks good! How do you like the Vltor upper?
…
My first build using a Vltor upper.
Installing the barrel was different than any other build I had done. This could be because of the monolithic design. I had to actually tap the barrel with a rubber mallet to seat it into the upper. It was a very tight fit. Even without the barrel nut on, there would be no way to remove the barrel without driving it out of the receiver. I have never experienced this before.
I do like the upper, it has proven to be a tack driver at 100 yards using hand loads.
badass. my voltor-1a was tight as hell. some moly grease and mallet did the trick.