Long story short, I’d like to use a surefire silencer on an ak. Right now I have a stripped wasr waiting to be cut and threaded. It’s getting permed so I need to have a solid decision on what thread to use.
Can the 14x1 socom flash hider index off the muzzle or is that a no-go?
The threads on here now are 13.5mm od, I’m assuming they are “14x1lh”. If I go to 1/2-28 the diameter hardly changes and I can silver solder a precision amarmament adapter up to 5/8-24 and have a sold shoulder. Thoughts?
The current diameter where the threads will be is 0.586"
. Yes. The SF Socom FH uses small shims that index on the end of the barrel. It doesn’t index on the shoulder like other SF muzzle devices. The AK74 flash hiders also index off the muzzle as well.
The threads on here now are 13.5mm od, I’m assuming they are “14x1lh”. If I go to 1/2-28 the diameter hardly changes and I can silver solder a precision amarmament adapter up to 5/8-24 and have a sold shoulder. Thoughts?
Likely the threads are M14x1lh already. My Wasr is. Save yourself the trouble of the adapters and just use a Surefire AK FH or Warcomp. The Warcomp works well on the AK and does stay put with Rocksett. Perm install with silver solder would work well too.
I am waiting on my 762 mini to get its stamp, but have shot it with a 300 sps and 762RC. the jury is out until I try it with the mini. It is really front heavy with a long suppressor on it, but it does function well
I’m cutting the barrel and “can do any thread I want” but I’m limited due to barrel od. I guess making sure the muzzle face is perpendicular to the bore is the most impotent part?
I’m cutting the barrel and “can do any thread I want” but I’m limited due to barrel od. I guess making sure the muzzle face is perpendicular to the bore is the most impotent part?
That and concentricity of the threads is always something to keep an eye on. I am assuming the WASR is 7.62, so it becomes a bigger project if you change threading to 5/8X24 (15.9mm-ish) to use a .30 cal muzzle device. Cut threads to 1/2x28, then adapter to 5/8X24 then muzzle device. A good machinist can do it, but keeping M14x1LH threads is a much easier job due to the barrel OD and minimizes the complication of timing multiple threaded connections. The new threads can be cut to time with the muzzle device as well, minimizing or eliminating the shims.
My own WASR is on my list of projects to do the chop and perm install, too. I am going to chop it, swap the front sight for an AK100 type gas block, have the machinist time the threads to the muzzle device (in this case an AK Warcomp), then silver solder it on as a suppressor host. I think that lightening the front end will be better balanced with a silencer added.
When I checked into it and basically got in line for machine time with a local shop (barrel chop scheduled for April, since the new gas block is supposed to be back in stock then), a recrown to 11 degrees was part of the service. With an 11 degree crown, indexing wouldn’t be a problem. My WASR has a Warcomp on it and it was indexed on the original crowned barrel.