Aimpoint 3x & LaRue Mount Problem...........

[b]I recently bought the Aimpoint 3X Magnifier with LaRue Tactical QD Mount
(high).

For the life of me I can’t figure out how the mount attaches to the Aimpoint magnifier.

In the photo on the LaRue web page, the magnifier shown is mounted immediately forward of the fat part of the housing.It appears that there’s a recessed band circling the magnifier that the ring of the mount grips and sits flush with the forward surface area of the magnifier.

The magnifier I received has no recessed area for the mount to secure to…or recess in to.
Additionally, the area of the magnifier, forward of the thick part of the
housing, has a diameter greater than that of the mount…it would appear. The
mount ring doesn’t seem to split as does the M3 mount I have from La Rue. It
only seems to have a screw at the top to tighten or loosen. The bottom appears fixed.

I have the sinking feeling I’m going to regret writing this thread, and when this is
explained the full extent of my stupidity will be realized, but I have honestly
not been able to figure this out.

Thanks in advance![/b]

Cut the rubber.

[b][COLOR=“Navy”][COLOR=“DarkSlateGray”]Cutting a band around the magnifier doesn’t change the diameter at the end…to allow the unsplitable ring to slip over it to reach the cut out. Do you peel off the front portion of the rubber once a ring is cut, slide the mounting ring to its position and then replace the front portion of the rubber housing?? (and if that’s the case, why wouldn’t some sort of “its necessary to partially destroy the rubber Aimpoint housing to properly install this mount” come with it?)

I don’t feel entirely stupid after reading this because there’s nothing included with either the LaRue mount, nor the Aimpoint magnifier that indicates cutting anything is necessary…though there’s really no other possibility I suppose. I would have thought the LaRue mount might have come with something stating that cutting the rubber housing is involved, how to best do it, where on the housing one should make the cuts…and all that. The photo above, to me, looks like the housing came from the factory with the cut out in it already. Looks molded in the shape its in, rather than cut with a straight edge. Even the rubber that meets the scope ring appears molded in the photo above rather than cut…and it’s not an entirely natural thing to put a razor to the rubber housing of a $400 item as is the case here.

Is what I stated above how one gets the ring in to position?[/COLOR][/COLOR][/b]

Yes you have to cut the rubber and pull the cut end off. It’ll then be a 30mm tube. It looks like Mfinger cut the cutoff end down a little and then reinstalled it on the magnifier for a custom look and to protect the tube.

Thanks for the info as well. I’m considering going that route and was not aware the rubber has to be cut off.

5POINT56

I would have posted the same question in a few weeks :slight_smile:

There are other mounting options that don’t involve cutting the rubber housing…but I like LaRue stuff and think this particular mount ends up doing the trick nicely…just somewhat surprised that there was no mention of this aspect of the install.

Like I said, it doesn’t really come naturally to take a razor to a $400+ optical part…and a few words from LaRue included with the mount stating this would have been helpful.

No big deal…easy enough to handle now.

If you will email your question to <sales@laruetactical.com> you will be suprised how fast Austin or one of the others will get back to you. :slight_smile:

Emailed them last night, hadn’t heard back by 1pm eastern time, so figured I’d call. Prompt confirmation that the rubber is to be cut.